User manual DIGITECH VOCALIST LIVE 3 INSTALLATION

[. . . ] Vocal Harmony & Real-Time Pitch Correction for Guitarists Owner's Manual WARNING FOR YOUR PROTECTION READ THE FOLLOWING: KEEP THESE INSTRUCTIONS HEED ALL WARNINGS FOLLOW ALL INSTRUCTIONS THE APPARATUS SHALL NOT bE ExPOSED TO DRIPPING OR SPLASHING LIqUID AND NO ObjECT FILLED WITH LIqUID, SUCH AS vASES, SHALL bE PLACED ON THE APPARATUS CLEAN ONLY WITH A DRY CLOTH. DO NOT bLOCK ANY OF THE vENTILATION OPENINGS. INSTALL IN ACCORDANCE WITH THE MANUFACTURER'S INSTRUCTIONS. DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS, HEAT REGISTERS, STOvES, OR OTHER APPARATUS (INCLUDING AMPLIFIERS) THAT PRODUCE HEAT. [. . . ] Fully clockwise and the harmonies are quite loose. 19. Setup Button Press the Setup button to enter Setup Mode. Subsequent presses step you through the various global parameters. In Setup Mode use the + (Voicing 1) and ­ (Patch) buttons to adjust the parameter values. 20. Patch Button This button cycles through the Vocalist Live 3's five Harmony Patches. To save harmony settings to the current Harmony Patch and A/B Parts, press and hold the Harmony Patch button until the selected Patch Number flashes. 21. Voicing Buttons There are individual Voicing controls for each of the two Harmony Voices. Pressing the Voicing button of the corresponding Harmony Voice will cycle through the Voicing options. 22. Voicing Display These LEDs display the currently selected Voicings. To disable a Harmony Voice, press the button until none of the LEDs is lit for that Voice. Note: The exact harmony note choice of the various Voicing shift settings depends on variables such as current note or chord, chord history and lead voice note. 7 23. Gender Display The Gender Display indicates the currently selected gender for that voice. Note that when there are no bars lit on the Gender Display, the Gender setting is disabled for the corresponding Harmony Voice. 24. Gender Buttons Separate Gender settings can be applied to each of the two Harmony Voices. By pressing the Gender button of the corresponding Harmony Voice, you can cycle through the Gender shifts from Masculine (M) to Feminine (F). 8 Rear Panel 3 6 1 2 4 5 7 8 9 10 1. Input Gain This adjusts the input level of the Lead Vocal signal for both the Mic In and Line In. The relative signal strength can be determined by the Vocal Signal Strength indicator on the front panel. 2. Mic In and Line In The Vocalist Live 3 uses a combo jack for vocal input. This jack will accept either a balanced mic-level signal on the XLR portion of the jack or a line-level signal on the ¼ portion of the jack. The ¼" jack accepts both balanced TRS and unbalanced TS inputs. 3. 48V Phantom Power Switch Pressing this switch turns on the 48V phantom power to the Mic In. With the switch in the out position, the 48V phantom power is turned off. Note: Phantom power is normally only needed with condenser microphones and should never be used with ribbon microphones. To avoid damaging the microphone, please consult your microphone documentation to ensure phantom power is applied only when appropriate. 9 4. [. . . ] Once it is released, the Harmony Voicings are bypassed. Select the desired mode using the +/- buttons. Low-cut Filter On/Off Press Setup until LC appears in the Display. This is the Low Cut filter setup menu that lets you turn the 75 Hz Low Cut filter on or off. After a moment the LC will disappear and the Display will show whether the Low Cut filter is turned on or off. [. . . ]