User manual DIGITECH XP300

[. . . ] The warranty card must be mailed within ten days after purchase date to validate this warranty. DigiTech warrants this product, when used solely within the U. S. , to be free from defects in materials and workmanship under normal use and service. DigiTech liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned to DigiTech WITH RETURN AUTHORIZATION, where all parts and labor will be covered up to a period of one year. [. . . ] Status Display - The Status Display window shows the current information including: bypass, current effect program number, and Chromatic Tuner information. When the XP-300 is in Program mode (Factory or User), the display will either read: 1-40 (Factory) or U1-U6 (User). *Note- A complete listing of all Factory programs is located on the bottom panel of the XP-300. 4. Program UP/(Hold)DOWN Switch - Lets you select programs. Pressing once will move up through the program menu. Press and hold and the XP-300 will move down through the program menu. BYPASS/(Hold)TUNER Switch - Puts the unit into Bypass by pressing the footswitch once. To select the Tuner, press and hold the footswitch until the display reads: tu, indicating that you are in Tuner mode. Expression Pedal - Controls the selected effect or volume. Input Level Control - Sets the amount of signal being sent into the unit. The ideal setting for the input control of the XP-300 is to set the input level at a point where the Clip LED indicator occassionally lights. 5. 6. Input Jack - Connect instrument here using 1/4" guitar cord. Left (Mono) Output - This is the Left (Mono) output of the XP-300. It can be used alone or together with the Right output to produce stereo imaging effects. Right Output - This is the Right output of the XP-300. 11. Mode/(Hold)Program - This button is used to put the XP-300 in and out of User mode. The beauty of the User mode is, that the XP-300 will give you the opportunity to store up to 6 of your favorite factory programs in the same area. This will save you the toe-tap dancing ritual of accessing programs. To store a Factory program to a User program location, the procedure is as follows: First, select the Program to be stored. [. . . ] The currently played note is displayed in the left character of the status display window, while the intonation is displayed in the RIGHT character of the window. When the input note is in tune, the display will read: When the note is flat, the intonation character will rotate counter clockwise as shown: When the note is sharp, the intonation character will rotate clockwise as shown: The faster the character spins (either clockwise or counter clockwise), the more out of tune the note is. Bypass Mode To place the XP-300 in bypass mode, press the <BYPASS/(Hold)TUNER> footswitch once. When the XP is in Bypass mode, the Expression pedal is inactive, but programs can still be selected using the <UP/(Hold)DOWN> footswitch while the unit is in bypass. [. . . ]