User manual DIRT DEVIL CENTEC JUBILE M 2828.3

[. . . ] 1 Overview of your Centec Thank you for purchasing the Centec and your confidence in us. As an example) Carrying-handle "Carpet/hard floor" selector Parking hook Telescopic tube stop catch Telescopic tube Bypass vent 10 Furniture brush 11 Crevice nozzle 12 Accessory bracket 13 Emptying button 14 Fitting mark on the dust container 15 Fitting mark on the dust container cover 16 Motor protection filter 17 Release button for the dust container 18 Dust container cover 19 Central lamellae filter 20*Filter fleece (optional*) 21 Dust container 22 MAX marking on the dust container 23 Dust compartment bottom plate 24 Baffle 25 On/Off switch 26 Cleaning indicator 27 Suction power control 28 Parking bracket 29 Cable retraction button 30 Exhaust filter 31 Filter holder 32 Exhaust filter cover release buttons 33 Exhaust filter cover 34 Operating Manual 35*Long flexible crevice nozzle (optional*) „ Parquet brush (Fig. 2/3*, optional*) * depending on model and scope of delivery Technical data Type of appliance Model Model number Voltage Power : bagless cylinder vacuum cleaner : Centec : M2828 (-0/-1. 3 kg Technical and design specifications may be changed in the course of continuous product improvement. [. . . ] 2/3*) This has a rotating brush head and is most suitable for thoroughly deep cleaning of carpets. The brushing also raises the carpet pile. 2/6*) Use this to vacuum dust from distant, hard-to-reach places. A B NOTE: When you use the long, flexible crevice nozzle, under certain circumstances the pressure inside the vacuum cleaner might drop too far thus triggering the safety valve. A whistling noise (depending on the vacuum cleaner model) and greatly reduced suction performance. In this case, depending on the vacuum cleaner model and equipment, you have to reduce the suction power or open the bypass vent until the valve no longer triggers. Push the accessory bracket onto the telescopic tube as shown, or onto the handle (Fig. Push nozzles not in use onto the stubs of the accessory bracket (Fig. Only attach the nozzles if the appliance is not connected to the power supply. The cylinder vacuum cleaner could be switched on by accident. 1 ATTENTION: Before vacuuming, make sure that the fitted nozzle suits the surface to be cleaned. Attach the selected nozzle to the bottom end of the telescopic tube (Fig. Insert the end of the suction hose into the intake opening (Fig. 5/A) of the vacuum cleaner until you hear and feel it locking into place. Insert the handle into the upper end of the telescopic tube (Fig. Adjust the length of the telescopic tube (Fig. Press down the release latch on the tube to do this. Then extend the telescopic tube to the desired length. Let go of the release catch while pulling until it locks in place. Check appliance and power cord before each use. a damaged appliance must never be used. NOTE: Your cylinder vacuum cleaner is equipped with a safety switch to prevent overheating. [. . . ] Put the cleaned or new exhaust filter back into the filter holder. Now put the filter holder with the freshly fitted filter back into its receptacle (Fig. Fit the exhaust filter cover on the bottom side first (Fig. 4 Spare parts and accessories ATTENTION: „ The following accessories and spare parts can be reordered: Item number 2828001 M203 M209 M232 Description Filter set 5 pcs, consisting of 1 central lamellae filter, 1 motor protection filter, 1 exhaust filter and 2 filter fleeces 1 parquet brush 1 turbo brush 1 long flexible crevice nozzle Only use original spare parts from the scope of delivery or those that you have acquired by reordering. [. . . ]