User manual DIRT DEVIL DDC1800

[. . . ] Remember that Turbine Powerheads operate whenever they are connected to a running vacuum. If children are present, make sure to turn vacuum system off when leaving Powerhead unit unattended. Do not attempt to service or unclog Turbine Powerhead while unit is running. Page 1 p/n 8429 1/06 Use & Care of Your Turbine Powerhead (A) ATTACHING THE TURBINE POWERHEAD To attach your metal wand, simply insert wand into Powerhead neck until it fits snugly. The built-in, locking mechanism will prevent the wand from coming loose. [. . . ] To detach wand, depress wand release tab on back of neck with foot or hand and twist wand free. Inserting the Wand Push here to Release Wand The wand can be locked in an upright position by pushing it forward until the lock is engaged. This locked position is convenient for storage and lifting the Powerhead. To release wand from the vertical locked position, gently place foot on Powerhead, grasp wand and pull back. Page 2 Use & Care of Your Turbine Powerhead (B) OPERATING PROCEDURES Your Turbine Powerhead runs off the airflow of your vacuum system. Whenever it is attached to an operating vacuum system, it will be running. No adjustments to the powerhead are necessary for different types of carpeting. To ensure maximum efficiency of the Turbine Powerhead, make sure that any filters, bags and cleaning hoses in your vacuum system are clean and free of blockage. Avoid picking up water or spilled liquid with your Turbine Powerhead. The vacuum system is designed for dry pick up only. (C) CLEANING ROLLER BRUSH Turn off vacuum system and disconnect Powerhead. Threads, string, carpet fiber, fuzz and similar items may become wound around the beater brush. Slide the brush/belt assembly back into the housing recesses so the supports seat properly into the housing. The assembly is designed to fit only one way into housing. NOTE: The brush will rotate in the wrong direction if the belt is twisted incorrectly. Replace belt cover. Baseplate Shaft 11. Lift Rollerbrush and Belt straight up to remove Proper Belt Orientation Position Belt between these two Flanges Page 5 TROUBLESHOOTING THE TURBINE POWERHEAD CAUTION: Moving parts—disconnect from vacuum system before servicing unit. Use the chart below to troubleshoot common problems you may experience with your turbine powerhead. If you cannot solve the problem using the solutions below, please contact your distributor or dealer for service. Turbine Runs Slow Check for clog at air intake. Clean central vac power unit guard screen/filter. Check for clog in tube line Ensure belt orientation is correct. [. . . ] Clean central vac power unit guard screen/filter. Check for clog in tube line Ensure belt orientation is correct. OTHER REPAIRS For repairs or service beyond those described in this manual, please contact your servicing distributor or dealer. Visit www. turbocats. com for servicing dealer contact information. [. . . ]