User manual DIRT DEVIL M2881-9 CENTRINO CLEAN CONTROL

[. . . ] Thanks for purchasing the Centrino Cleancontrol and your confidence in us. Safety notices It is especially forbidden: „ To vacuum-clean: - Hair, fingers and other parts of the body. - water and other fluids, especially damp carpet cleaning agents. Moisture inside the appliance can cause a short-circuit. [. . . ] Then extend the telescopic tube to the desired length. To set it let go of the release catch whilepulling until it locks in place. Attach the accessory holder to the suction tube as shown(Fig. Your cylinder vacuum cleaner is now ready for use. ATTENTION: Take care that you don't accidentally press the dust container release catch when carrying the vacuum cleaner. „ To store it or when not working with it you can hook the parking-hook onto the parkingbracket. Insert the mains plug into a socket with ground/safety contact. Switch on the cylinder vacuum cleaner with the on/off switch (Fig. 3/1) according to the type of flooring: for deep- and short-pile carpets, runners (Fig. When working with the cylinder vacuum cleaner, pull if after you like a sleigh. Follow the respective recommendations of the flooring manufacturers. 7 It is recommended to first retract the telescopic tube (Fig. ATTENTION: Never store the appliance next to heat sources (e. „ Before storing it for a prolonged time empty the dust container and disposeZChapter 3. 1, "Emptying the dust container" of its contents properly. „ Always store the appliance in a cool, dry place and out of reach of children. 1/4) you can quickly reduce the suction power if less power is needed, e. 3 Cleaning / changing the exhaust filter Maintenance Emptying the dust container 3. Remove any residual dust that may have collected in the dust compartment. Also clean or exchange the motor protection filter on this occasion. Put the dust container back into its holder. You must feel and hear it click into place. [. . . ] To thoroughly clean the central laminar filter without water, use the supplied furniture brush as shown (Fig. Put the cover back on the dust container and lock by turning it clockwise. Take care that the release catches for dust cover and bottom plate correspond when fitting them (Fig. Do not put the filter back into its holder before it is completely dry. [. . . ]