User manual DIRT DEVIL SPIDER 2.0 M612

[. . . ] In non-EU countries the minimum warranty requirements in the respective country apply. This does not apply to batteries or rechargeable batteries which have become faulty or have a reduced service life as a result of normal wear or improper handling. We reserve the right to make changes to technical and design specifications in the interest of continuous product improvement. © Royal Appliance International GmbH 14 EN „„ Children must not perform cleaning or user maintenance tasks without supervision. [. . . ] –– Hot ash , burning cigarettes , matches and highly flammable substances ➔ Risk of fire!€– Water and other liquids ➔ Risk of short circuit!„„ Carrying out repairs yourself ➔ Risk of injury and loss of entitlement to free replacement!1  : 1 Charging indicator light • Flashes blue, when the battery pack is charging • Lights up with constant blue light when the battery pack is fully charged • Flashes alternately with battery indicator during operation 2 Cleaning indicator • Lights up red when dust bin must be emptied 3  Battery indicator • Lights up red when battery pack must be charged or appliance has no contact to floor • Flashes alternately with charging indicator light during operation Unpacking and preparing 1 Check that the unpackaged contents are complete (Fig. If you notice any transport damage or if anything is missing, contact your dealer immediately. 2 When using the appliance on hard floors, attach the round brooms one after the other as shown (Fig. If you want to remove the round brooms, grab the bristles and pull the round brooms away from the appliance (Fig. NOTE: EN Inserting the battery pack Ensure that the sticker with the words “This side up” is facing up and the contacts in the battery compartment are able to engage in the apertures in the insulation of the battery pack. For this purpose, let the battery pack first slide into the battery compartment on the side with the contacts (Fig. 6 ) and then press the battery pack into the battery compartment on the other side (Fig. The battery pack must rest evenly on the bottom of the battery compartment. 3  Reattach the cover of the battery compartment and slide it firmly into its bracket until you hear and feel it click into place. 2  Adjust the position of the slide controllers to set the sensitivity of the anti-fall sensors at the bottom of the appliance (Fig. 1 / 12 ): • Position 0 (smallest opening) for light floors and low steps • Position 1 (Fig. 12/ B ) for light floors and slightly higher steps • Position 2 for dark floors and even higher steps • Position 3 (largest opening, Fig. 12/ A ) for dark floors and high steps Charging the battery pack !Only use the mains adapter included in the scope of supply to charge the battery pack. 2 Connect the plug of the mains adapter cable to the charging socket on the appliance (Fig. 1 / 1 ) lights up blue to indicate the charging process. 4 After a maximum of 4 hours, the charging indicator light remains blue. All 3 slide controllers have to be set to the same setting. If your robot constantly travels backward on dark floors, you must select position 3 (largest opening). [. . . ] 6  Reinsert dust bin with filter into the appliance > “Inserting dust bin and filter” on page 18. Cleaning the dust bin and the filter !Switch off the appliance before you start troubleshooting. never use a faulty appliance , charger or rechargeable battery. [. . . ]