User manual DIRTDEVIL M087400 #11-06

[. . . ] Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes. Do not use without dirt container and filters in place. [. . . ] Insert handle fastener into the back of the Power Brush Tool caddy. Attach back panel of cleaner by pushing down into place (Diagram 2). Insert the two (2) screws into the front of the back panel and tighten until secure (Diagram 2a). Attach lower hose to right side of back panel (Diagram 3). Insert one (1) screw through the back of the hose to secure (Diagram 3a). Insert the one (1) screw into the front and tighten until secure. Push hose wand down into the right side of cleaner. Attach tools: (a) Slide the dust brush onto post on the upper tool caddy with bristles facing out. (b) Clip Power Brush Tool onto the front of the Power Brush Tool caddy. (c) Slide the extension wand/crevice tool into round slot on the front right side of tool caddy. Turn cleaner on by depressing foot pedal located on the back left side of the cleaner. CAUTION: Brush agitator continues to rotate while hose is removed or in use and at all times while cleaner is on. Keep hair, loose clothing, fingers, and all parts of body away from brush area while cleaner is on. Cleaner must be in the upright position to lift the rotation brush off the carpet when cleaning above the floor. Turn Quick Cord Release for easy cord removal. store cord in cord guide (see Features - pg. 5) to keep out of the way while vacuuming. To release handle, push the handle release pedal located on the lower left side of the cleaner. Move the handle and adjust it to the desired position for (a) storing the upright, (b) operating the cleaner, and (c) de-press the handle release pedal again to clean under furniture. "Self-Propelled" feature will work as vacuum is pushed forward and pulled backward. Turn the height adjust knob to match the surface being cleaned. Cleaner must be in its upright position to raise brushroll. [. . . ] To reassemble, be sure tabs are engaged and pivot the lower housing closed. Power cord not firmly plugged into outlet. Take to service center or call 1-800-321-1134. Cleaner won't pick-up or low suction In the event that further assistance is required, see your Yellow Pages for an authorized Royal ® Dealer. [. . . ]