User manual DIRTDEVIL M087800CA 3-03

[. . . ] Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts. Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes. Do not use without dirt container and filters in place. [. . . ] Warrants this vacuum cleaner to be free of defects in material or workmanship commencing upon the date of the original purchase. Refer to your vacuum cleaner carton for the length of warranty and save your original sales receipt to validate start of warranty period. 5) to keep out of the way while vacuuming. Turn the height adjust knob to match the surface being cleaned. nOTE: For easiest adjustment , place cleaner in full upright position. B a AVANT Insert the one (1) screw into the front and tighten until secure. Attach tools: (a) Slide the dust brush onto post on the upper tool caddy with bristles facing out. (b) Slide the extension wand/crevice tool into round slot on the front right side of tool caddy. Insert handle fastener into the back of the turbo tool caddy. Clip turbo tool onto the front of the turbo tool caddy. CAUTION: Brush agitator continues to rotate while hose is removed or in use and at all times while cleaner is on. Keep hair, loose clothing, fingers, and all parts of body away from brush area while cleaner is on. Cleaner must be in the upright position to lift the rotation brush off the carpet when cleaning above the floor. Push hose wand down into the right side of cleaner (Diagram 1a). Cleaner must be in its upright position to raise brushroll. Turn cleaner on by depressing foot pedal located on the back left side of the cleaner. If additional length is needed, use the extension wand and crevice tool. To release handle, push the handle release pedal located on the lower left side of the cleaner. Choose any of the handy accessories or use the hose alone. Simply push the attachment firmly onto the end of the wand or hose handle. Move the handle and adjust it to the desired position for (a) storing the upright, (b) operating the cleaner, and (c) depress the handle release pedal again to clean under furniture. Use the carry handle on the back of the cleaner to move the cleaner from room to room. [. . . ] Always identify your cleaner by the model number and manufacturing code when requesting information or ordering replacement parts. (The model number appears on the bottom of the cleaner. Set carpet height adjust lever to appropriate to push setting for carpet being cleaned - Pg. Headlight not working Cleaner tools won't pick-up Dust escaping from cleaner Cleaner won't pick-up or low suction Cleaner won't run PROBLEM Power cord not firmly plugged into outlet. [. . . ]