User manual DIRTDEVIL M088300B 2-03

[. . . ] Do not pull or carry by cord, use cord as handle, close a door on cord, or pull cord around sharp edges or corners. Do not handle plug or appliance with wet hands. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow. Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts. [. . . ] To secure, insert two (2) screws into the front of the back panel. Align carry handle holes with holes on back panel. Insert two (2) screws into the holes and tighten until secure. Place turbo tool caddy onto the front of the vacuum midsection. Insert the two (2) screws into the back of the handle and tighten, making sure the tool caddy is attached. Clip turbo tool onto the front of the turbo tool caddy. Push hose wand down into the right side of cleaner (Diagram la). Align tabs on clear dirt passage window with the slots on the lower hose cuff. Push and turn hose clockwise until secure. ~ t t tools: h slide the ~ ~ (a) dust brush onto post on the upper tool caddy with bristies facing out, (b) Slide the extension wandlcrevice tool into round slot on the front right side of tool caddy. Align slots on lid with tabs on cup (Diagram 4). nOTE: There is a guide arrow on back of lid. Align arrow with right edge of dirt cup handle and turn clockwise until secure (Diagram 4a). 5) to keep out of the way while vacuuming. Set aligning tab on bottom of dirt cup into rectangular slot on cleaner (Diagram 5), and push to snap into place (Diagram 5a). CAUTION: Brush agifafor continues to mfate while hose is removed or in use and at all times while cleaner is on. Keep hair, loose clothing, fingers, and all parts of body away fmm brush area while cleaner is on, Cleaner must be in the upright positionto lift the rotation blush off the calpet when cleaning above the floor. Turn cleaner on by depressing foot pedal located on the back left side of the cleaner. To release handle, push the handle release pedal located on the lower left side of the cleaner. NOTE: Rotating brush could cause area rug fringe to become tangled within cleaner. Use caution when vacuuming throw rugs with fringe. Cleaner must be in its upright position to raise brushroll. [. . . ] To reassemble, be sure tabs are engaged and prvot the lower housrng closed Power cord not firmly plugged into outlet. Take to service center or call 1-800-321-1 134. Cleaner won't pick-up or low suction Set carpet height adjust lever to appropriate to push setting for carpet being cleaned - Pg. In the event that further assistance is required, see your Yellow Pages for an authorized Royal" Dealer. [. . . ]