User manual DIRTDEVIL M088500 1-01

[. . . ] Warrants this vacuum cleaner to be free of defects in material or workmanship commencing upon, the date of the original purchase. Refer to your vacuum cleaner carton for the length of warranty and save your origmal sales receipt to valldate start of warranty period. If the vacuum cleaner should become defective within the warranty period, we will repair or replace any defective parts free of charge. The complete machine must be delivered QreDaid to any ROYAL Authorized Sales & Warranty Service Station. [. . . ] AlTACH TOOLS: (Diagram 3) (A) Slide 2-in-1 tool onto tool clip on the back panel with bristles facing out. (B) Slide the Telescopic wand, small end down, into the round slot behind handle. (C) Slip crevice tool into square slot behind handle. WraD cord around hooks on back of cleaner. The Quick Cord Release turns for easy access ", to the cord (D). Power pedal located on lefi side of back of unit (Diagram 1). To release handle push pedal to the side with foot (Diagram 2). Use cord guide to store cord out of way while vacuuming. Handle should be in the upright position before adjusting the carpet setting (Diagram 3). adjust lever to match the surface being cleaned (Diagram 4). Once height is selected the nozzle will go to the correct position. CarpeUHose Selector located on the lower back of the cleaner should be pointed at the "floor" position (Diagram 5a). If the cleaner is difficult to push, adjust to a higher carpet level setting. Move the handle and adjust it to the desired position for (a) storing the upright, (b) operating the cleaner, and (c) depress the handle release pedal again to clean under low furniture (Diagram 3). NOTE: Rotating brush could cause area rug fringe to become tangled within cleaner. Use caution when vacuuming throw rugs with fringe. ABOVE FLOOR CLEANING Cleaner must be in the upright position to lift the rotating brush off the carpet when cleaning above the floor. Remove the hose from the side of the cleaner using the handle (Diagram 6). CAUTION: Brush agitator continues to rotate while hose is removed or in use and at all times while cleaner is on. Keep hair, loose clothing, fingers, and all parts of body away from brush area while cleaner is on. Pull and turn the CarpeUHose Selector counterclockwise to the "hose" position to open up airflow to the hose (Diagram 5). Choose any of the handy accessories or use the hose alone. [. . . ] Push bulb into socket to replace (Diagram 2). Power cord not firmly plugged into outlet. Take to service center or call 1-800-321 134. Cleaner won't pick-up or low suction Cleaner is difficult to push In the event that further assistance is required, see your Yellow Pages for an auth6rized Royal Dealer. [. . . ]