User manual DIRTDEVIL M089000WG 2-05

[. . . ] Please read these instructions carefully before using your cleaner. Cleaner assembly may include small parts. Small parts can present a choking hazard. For quick reference, please record your vacuum information below. [. . . ] Your new upright also has exclusive curved fan blades which create more air volume per minute at less motor speed than straight blades. This means more efficient carpet cleaning and less electricity consumption; thus you save time and money. NOTE: Do not connect cleaner to electrical outlet until it is assembled. Slide the upper and lower handle sections together, aligning the square or round holes on both handle sections. From the literature pack, get the square neck curved head bolt, curved washer and 7116" nut. Lnsert square neck curved head bolt through square aligned hole opening, until curved head is flush with handle. Place curved washer over threaded end of bolt and tighten 7/16" nut with appropriate tool (tool not included). All except models below: Remove wing nut and bolt from fork completely. Insert handle and power cord into the fork. Models with a &tail: Loosen the large wing nut on the handle fork located on the motor unit. Inset the handle into the fork and tighten the large wing nut. Wind the extra-long electrical cord over the cord hooks when cleaner is not being used. The electrical cord is permanently attached to the upper part of the handle and a short connector plug is at the other end. If not, follow these easy steps: Pry belt cover from front of cleaner with screwdriver to remove or rotate the grey rubber nozzle cover* (Diagram 1). *Feature may differ according to model Insert belt lifter tool through belt loop, being sure to hook belt around the lip of the belt lifter tool from the left (Diagram 2). Using the tool as a pry bar, slip the belt onto the motor shaft until the belt lifter base meets the shaft. Gently turn the tool to the right (clockwise) to insure proper belt placement. The front of the belt will be to your right when installed properly (Diagram 3). Snap belt cover or rotate the grey rubber nozzle cover over the belt access opening. PLUG IN THE CLEANER Plug the electrical cord into your most convenient outlet, making sure the voltage indicated on the serial number date of vour cleaner is the same as vour electrical source. SET THE NOZZLE HEIGHT Infinite Height Settings: Lets you clean every type of carpet. Your new upright will glide easily over your carpets and rugs, "air-lifting" them as it vacuums. [. . . ] Slip the belt over the revolving brush before brush is put into the new position. Align the arrow on the brushroll with the direction of the arrow on the nozzle guard as shown in (Diagram 1). If the belt dislodges when you turn the unit "on", the belt is on "backwards". In nozzle or belt area while the unit is operating. [. . . ]