User manual DIRTDEVIL M089800 3-01

[. . . ] Thank you for your support of Dirt DevilBproducts. Warrants this vacuum cleaner to be free of defects in material or workmanship commencing upon the date of the original purchase. Refer to your vacuum cleaner carton for the length of warranty and save your original sales receipt to validate start of warranty period. If the vacuum cleaner should become defective within the warranty period, we will repair or replace any defective parts free of charge. [. . . ] (B) Slide 2-in-1 tool onto upper back panel with bristles facing out. (C) Slide the Telescopic wand, small end down, onto the lower back panel. (D) Slip crevice tool onto lower back ane el. Switch located on left side of cleaner directly above HEPA filter (Diagram 1 . Use the window on the nozzle to see if the brushril is moving. As you switch to different carpet piles, move the height adjust knob to match the surface being cleaned (Diagram 3). Depressing handle release a second time while in use will lower cleaner to lie flat, allowing to clean under furniture. NOTE: Rotating brush could cause area rug fringe to become tangled within cleaner. Use caution when vacuuming throw rugs with fringe. NOTE: Cleaner must be "on" when activatina/deactivatina brushroll. Choose any of the handy accessories or use the h&e alone. A threshold stop is incorporated into the cleaner which enables it to be transported from barefloor to carpet by lowering the handle back until the nozzle is lifted off of the floor. *STRETCH HOSE AND HOSE ANCHOR: The Hose Anchor is used to prevent the vacuum from tipping while using the above floor cleaning attachments. Remove the stretch hose from side of the cleaner using the handle. Lay hose over the back of cleaner (Diagram 1) and secure hose anchor ring (Diagram 2a). Pull hose from hose handle for additional length (Diagram 2b)TELESCOPlC WAND: Remove wand from side of cleaner by pulling out at the top to unsnap and pull up (Diagram 3 . Twist ) and pull wand apart for extra length, as described on wand. Move lever to adjust height of nozzle to match the surface being cleaned (Diagram 4). If cleaner is difficult to push, adjust to a higher carpet setting. Use the carrying handle on the back of the cleaner to move cleaner from room to room (Diagram 5). NOTE: Do not push or pull cleaner forward while in the upriaht position leaning on back casters. The filter does not need to be replaced but should be cleaned regularly for maximum performance. [. . . ] 3 Take to service center or call 1-800-321 . 1 Power cord not firmly plugged into outlet. Cleaner won't pick-up or low suction Clean filters and clear blockages - Pg. Cleaner is difficult to push In the event that further assistance is required, see your Yellow Pages for an authorized Royal" Dealer. [. . . ]