User manual DIRTDEVIL M089890 3-01

[. . . ] Please read these instructions carefully before using your Vision with Sensor". Let us help you put your cleaner together or answer any questions, call: 1-800-321-1 134 (USA & Canada) website: www. For quick reference, please record your vacuum information below. CONGRATULATIONS You are now the proud owner of the Dirt DevilBVision with Sensor", with Power You Can SeeTM! [. . . ] Switch located on left side of cleaner directlv above HEPA filter (Dia ram 1 . Use the window on the nozzle to see if the brushroll is moving. As you switch to different carpet piles, move the height adjust knob to match the surface being cleaned (Diagram 3). Depressina handle release a second time while in use will lower cleaner to lie flat. NOTE:' ~otati;g brush could cause area rug fringe to become tangled within cleaner. Use cautio;; when vacuuming throw rugs with fringe. dIRT SENSORTM SYSTEM SIGNALS YOU WHEN CARPET IS CLEAN (DIAGRAM 5) The Dirt Sensor System uses sound and vibration to detect existing dirt. Light particles such as dust won't be detected. Embedded dirt will then be detected while vacuuming. Red lights indicate dirt is still being picked up. NOTE: Cleaner must be ''on" when activating/deactivatingbrushroll, 2. Continue to vacuum barefloors and rugs or use attachments for above floor cleaning. Remove the hose from the side of the cleaner using the handle (Diagram 5). Choose any of the handy accessories or use the hose alone. Simply push the attachment firmly onto the end of the wand or hose handle. A threshold stop is incorporated into the cleaner which enables it to be transported from barefloor to carpet by lowering the handle back until the nozzle is lifted off of the floor. *STRETCH HOSE AND HOSE ANCHOR: The Hose Anchor is used to prevent the vacuum from tipping while using the above floor cleaning attachments. Remove the stretch hose from side of the cleaner using the handle. Lay hose over the back of cleaner (Diagram 1) and secure hose anchor ring (Diagram 2a). Pull hose from hose handle for additional length (Diagram 2b). TELESCOPlC WAND: Remove wand from side of cleaner by pulling out at the top to unsnap and pull up (Diagram 3). Twist and pull wand apart for extra length, as described on wand. [. . . ] Use Phillips screwdriver to remove the five nozzle guard screws (Diagram 6). Slide the new front belt over the small pulley (Diagram 4). Slide the belt over the brushroll onto the area without bristles (Diagram 9a). Replace brushroll into nozzle pocket (Diagram 9). [. . . ]