User manual DIRTDEVIL M400 1-01

[. . . ] You are now the proud owner of a RoyaP vacuum cleaner. We trust your new purchase will bring you many hours of satisfaction. Our company designed and developed this product, and it is manufactured by us in Glenwillow, Ohio. We take great care to ensure top quality, but an occasional mistake may occur; thus, please check to be sure all components are included in your carton and that each is free from defects. [. . . ] To join wands together, push in pin of lower wand and lock into hole of upper wand. Together they permit a reach of over 11 feet, including the hose. Push pistol grip and upper wand together firmly until button snaps into place. Press down on button and pull to remove. This 10-inch brush has long, soft bristles that dust and buff at the same time. Inserted into the lower wand section, the brush will lock into place and then swivel conveniently as you clean. Cleans bookcases, lampshades, screens, televisions, picture frames, baseboards, and all metal, wood, or molded plastic furniture . The long soft bristles won't mar your furniture but will delicately lift the surface dust and whisk it away. Nozzle may be used with either both cleaning wands to reach drapery valances, the back of the sofa, and other hard-to-clean places. NOTE: To clean the brushes, just apply suction from the hose directly to the bristles. Cleans all hard-to-reach places including deep furniture crevices, button cushions, bookcases, baseboard corners, and automobile upholstery. It's also easier to clean behind ranges and refrigerators. To attach, push the end of the selected tool into the opening of the wand or pistol grip. With its separate motor and revolving brush system, the Power Nozzle actually lifts your carpet. The revolving brush gently sweeps the carpet clean of dust and dirt particles deep in carpeting. To attach, press down on wand until pin snaps into place and locks. The flat area of the tube seal should face towards the front of the power nozzle. To disconnect, position flat area of the tube seal to face toward the front of the pin. Push in on flat area of the tube seal to release locking pin and pull. To disconnect, press down on the convenient foot release lever at the collar of the power nozzle and pull up on the wand. When ordering a Power Nozzle, refer to the following grid: Make sure your tank cleaner is unplugged before assembling your power nozzle. (Model 4350) Lock cuffed end of wand over adapter on rear of nozzle. [. . . ] Then, you simply toss the "dusty" sheet or towel into your automatic washer for cleaning. Don't be concerned if the paper filter bag is not empty when you use the blower. The tank's MICROFRESH" Filtration System will entrap the dust and not allow it to recirculate during this use. When you finish using your Royal" tank as a blower, unplug your tank and reconnect the hose to the front end bell for vacuum cleaning. [. . . ]