User manual DIRTDEVIL M501

[. . . ] Do not pull on the cord to unplug the vacuum cleaner. Do not use the power cord to pull or carry the vacuum cleaner. Do not shut any door on the cord or pull the cord around sharp edges or corners. Keep the cord away from heated surfaces. [. . . ] PROPER VOLTAGE IS LISTED ON CLEANER 3. 2. PLATE. THE ROYAL PRINCE OPERATES ON 120 VOLTS A. C. DO NOT OPERATE THIS UNIT NEAR FLAMMABLE GASES OR LIQUIDS. TO PREVENT FIRE, DO NOT PICK UP HOT OBJECTS SUCH AS CIGARETTE BUTTS, ETC. This vacuum cleaner will operate best when serviced with genuine parts. To be sure that you receive genuine parts and service at fair prices, have your cleaner serviced at an Authorized Royal Dealer or see your Yellow Pages for a dealer near you. Should you experience any difficulties in operating this vacuum cleaner, report it immediately to the Dealer from whom it was purchased. Costs of any transportation to and from any place of repair are to be paid by the owner. The service parts used in this unit are easily replaced and readily available from your Authorized Royal Dealer or see your Yellow Pages for a dealer near you. You have purchased the finest hand vacuum cleaner available. This minicleaner with revolving brush action has most features found only on upright cleaners. Follow the instructions enclosed and it will give you years of efficient service. NOTE: REGISTER YOUR CLEANER TO VALIDATE WARRANTY. OPERATING INSTRUCTIONS A. BELT INSTALLATION AND REMOVAL NOTE: THE UNIT MUST NOT BE PLUGGED IN WHEN INSTALLING OR REMOVING THE BELT. 1. Remove the plug on the face of the cleaner. NOTE: PLUG MUST BE ON WHEN ATTACHMENTS ARE NOT IN USE. 3. Center and raise the belt with your left hand as shown. Using your right hand, dip the belt lifter in and hook the belt around the lip of the belt lifter. Slip the belt onto the motor shaft until the belt lifter base meets the shaft. 4. To insure proper belt placement, gently turn belt lifter clockwise and remove. Make sure belt is pushed back on shaft. 5. (right side of belt should be closest to you). NOTE: THE BELT WILL COME OFF IT NOT INSTALLED PROPERLY. 6. To remove the belt, hold belt lifter as shown in photo 2. Hook the belt on the right side of the motor shaft, turn counterclockwise and pull the belt towards you to release. BELT STYLE: 1 B. BAG REMOVAL AND INSTALLATION NOTE: UNPLUG CLEANER WHEN REMOVING AND INSTALLING BAG. 1. Twist to the left to remove. NOTE: KEEP BAG OPENINGS POINTED TOWARDS CEILING TO AVOID SPILLING DIRT. 2. [. . . ] When the brush has become slightly worn or where heavy brushing is desired, replace brush in holders with number "2" visible on caps at end of brush (as shown). For further brush wear, move brush roll to position "3". NOTE: ARROWS ON BRUSH ROLL AND METAL NOZZLE GUARD MUST BE POINTING IN THE SAME DIRECTION. When installing a new brush, number "1" should be visible on caps at end of brush. *not available on all models. G. STORAGE OF YOUR ROYAL PRINCE You can store your Royal Prince in the closet, laundry room, or any other convenient location. , HANG WANDS HERE 1. [. . . ]