User manual DIRTDEVIL MCE5500CA 11-03

[. . . ] Close attention is necessary when used by or near children. If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center for inspection. Call 1-800-321-1 134 or visit our website at www. Do not pull or carry by cord, use cord as handle, close a door on a cord, or pull cord around sharp edges or corners. [. . . ] Please include complete description of the problem, day of purchase, copy of original sales receipt and your name, address and telephone number. If you are not near a Warranty Station, call the factory for assistance at USA & Canada: 1-800-321-1134. use only genuine Royale replacement parts. The warranty does not include unusual wear, damage resulting from accident or unreasonable use of the vacuum cleaner. This warranty does not cover brushes, flat belts, filters and bulbs. This warranty does not cover unauthorized repairs. This warranty gives you specific legal rights and you may also have other rights (Other rights may vary from state to state in the USA). Press down firmly on body until it snaps into place (Diagram la). Push nozzle power cord into nozzle power cord clip on back of unit. NOTE: Make sure the excess power cord is tucked up and into car[/ handle (Diagram 2). Please read instruction manual for more detailed operating instructions prior to first use. The Hard Floor cleaner can be used to clean wood floors that have been sealed with a oolvurethane coatino . Fill remainder of Clean Water Tank with warm water up to the maxfill line (approximately 24 02. Replace CleanIDirty WaterTank into main body of cleaner. With both handle switch and NOZZLE SETTING pedal in position 2 and SOLUTION ONIOFF pedal engaged, slowly move cleaner forward and backward over area to be cleaned. SOLUTION ONIOFF pedal to stop the flow of solution and move the handle switch from position 2 to position 1. Your cleaner is equipped with a shut off valve within your Dirty Water Tank. Empty the Dirty Water Tank when the wet andlor dry debris reaches the "Debris Max Fill" line on the outside of the CleanIDirty Water Tank or the float rises, shutting off air flow through the nozzle. nOTE: You will hear a noticeable change in the pitch of the cleaner. This indicates a need to empty the Dirty Water Tank. [. . . ] Dirty water tank not installed correctly. Step on SOLUTION ONIOFF pedal to turn on solution dispense - Pg. Take to a service center or call 1-800-321-1 134. In the event that further assistance is required, see your Yellow Pages for an authorized Royalm Dealer. [. . . ]