User manual DIRTDEVIL MCE6000 1-01

[. . . ] Please read these instruction carefully before using your Easy SteamerTM. Let us help you put your cleaner together or answ. For quick reference, please record your vacuum information below. CONGRATULATIONS You are now the proud owner of the Dirt Devil@ Easy SteamerTM Deep Cleaner. [. . . ] If unable to remove the furniture, place plastic or foil under and around the legs until the carpet has dried completely. If the cloth remains clean, it should be safe to clean the carpet. Do not oversaturate carpet with cleaning solution while using Easy Steamer'". for heavily soiled areas , additional applications may be necessary. Allow plenty of time to dry carpet thoroughly. Wipe cleaning solution from woodwork and wood to prevent any damage. Try not to walk on carpet until it is completely dry. After carpet is thoroughly dry, vacuum the carpet using a cleaner with a revolving brushroll. Before cleaning, determine where you will start and end, making sure not to walk over previously cleaned areas. Try not to walk on the carpet until it is dry. If you need to walk on the carpet, place white towels on the areas you want to walk. If the carpet is not dry and the furniture must be placed back in the room, use plastic or foil under the furniture to prevent staining the carpet. Thoroughly clean the dirty water tank with hot tap water. Fill measuring cap with solution 2 times (approximately 4 oz. Fill remaining solution reservoir with hot tap water (Diagram 5). Using other cleaning solutions may cause excessive foaming. excessive foam will cause the float to shut off the vacuum prematurely. Using other cleaning solutions will void your warranty. Place bottom of solution reservoir into cleaner and rotate top into position until the lever snaps into place (Diagram 6). NOTE: Never leave unit unattended with power on. Turn OFF when emptying and filling reservoir. Step on handle release pedal (Diagram 8), to put unit in cleaning position. [. . . ] Mineral deposits and mildew can form which will affect the performance of your Easy Steamer. To remove belt cover, use Phillips screwdriver to remove the two screws. arrows (Diagram 2) show location of screws. Grasp belt cover near brushroll and lift out (Diagram 3). [. . . ]