User manual DIRTDEVIL MRY5500 10-03

[. . . ] Keep bystanders at least 25 feet away from the area of operation. use only manufacturer's recommended attachments. If appliance is not working as it should, as been dropped, damaged, left outdoors, or dropped into water, return it to a service center. Do not pull or carry by cord, use cord as a handle, close a door on cord, or pull cord around sharp edges or corners. [. . . ] Do not operate this machine near flammable materials such as solvents, thinners, fuels, grain dust, etc. If it should malfunction or breakdown, grounding provides a path of least resistancefor electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment-groundingconductor and grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances. DANGER - Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service person if you are in doubt as to whether the outlet is properly grounded. Do not modify the plug provided with the appliance -if it will not fit the outlet, have a proper outlet installed by a qualified electrician. This appliance is for use on a nominal 120-volt circuit and has a grounding plug that looks like the plug illustrated in sketchA below. Make sure that the appliance is connected to an outlet having the same configuration as the plug. No adapter should be used with this appliance. LnstallationlRemoval of Nozzle Base Nozzle base can be removed by turning knob to the right. The nozzle base can now be separated from vacuum housing. Handle Release To release the machine from upright position, push down on foot release as shown in example 2. Always start at the highest setting and rotate to lower setting if needed (see explanation below). The two indicator lights on the nozzle base allows the operator to monitor brush performance. when only the GREEN LIGHT is on , brush setting is correct. When both the GREEN and RED LIGHTS are on, the brush setting is too high. Lower brush setting until the RED LIGHT goes out. RED LIGHT may flicker when used on low nap commercial grade glue down type carpet. If RED LIGHT remains on continuously during brush operation at lowest setting (I), strip should be brush replaced. if brush assembly is obstructed , electronic control will shut off brush motor. Turn machine off and UNPLUG from ELECTRICALOUTLET. [. . . ] This warranty covers only labor and parts to Use place this product in correct operating condition and does not cover any other damages including consequential damages. This warranty does not apply to damage or malfunction caused by misabuse, abuse, negligence, accident, or damage due to transport. This warranty does not cover brushes, flat belts, filters, bulbs. This warranty does not cover unauthorized repairs. [. . . ]