User manual DLS IC426

[. . . ] If you feel unsure, turn over the installation job to someone better suited to it. Before making any holes, check for other installations behind the panels like girders, water pipes or electric cables. Use a pipe or cable detector to find out their location. [. . . ] The distance between the speakers depends on the size of the room and the distance to the listener. In general, the speakers should not be closer to the listener than 1, 5 meters (5 ft), and the distance between the speakers should not exceed the distance to the listener. If they are placed too far apart there will be a "hole" in the midrange, and if they are to close together you will loose the "depth" in the sound image. For Home theatre installations the speakers should not be placed closer to each other than the width of the screen, and the height around the centre of the screen. For use as surround speakers: A surround speaker should be placed behind, and approx. A roof mount often gives a good sound result. They come in both black and white colour. Make sure the cables don´t get jammed causing a short circuit as this can damage the output circuits of your amplifier. Make sure the amplifier is OFF when you connect the cables. If you connect more than one speaker in series or parallel, make sure the resulting impedance is in accordance with your amplifier specifications. Power 4 ohm 50 W 4 ohm 50 W 4 ohm 60 W 4 ohm 100 W 4 ohm 4 ohm 4 ohm 4 ohm 100 W 80 W 60 W 80 W Max power 100 W 120 W 90 W 160 W 160 W 120 W 90 W 120 W Sensitivity 90 dB 90 dB 91 dB 91 dB 90 dB 91 dB 91 dB 91 dB Magnet size 70 mm / 2, 75" 80 mm / 3, 15" 100 mm / 4" 58 mm / 2, 28" Neodymium 58mm / 2, 28" Neodymium 100 mm / 4" 90 mm / 3, 54" 100 mm / 4" Installation depth 60 mm / 2, 36" 65 mm / 2, 56" 70 mm / 2, 76" 125 mm / 4, 92" 70 mm / 2, 76" 90 mm / 3, 54" 80 mm / 3, 15" 93 mm / 3, 66" Mounting hole cut out size 166 mm / 6, 53" 192 mm / 7, 56" 192 mm / 7, 56" 260 x 206 mm 10, 2 x 8, 1" 284 x 203 mm 11, 2" x 8" 238 mm / 9, 37" 270 x 183 mm 10, 63" x 7, 20" 322 x 220 mm 12, 67" x 8, 66" Outer size Dimension 204 mm / 8, 03" 228 mm / 8, 98" 210 mm / 8, 30" 315 x 260mm 12, 4 x 10, 2" 335 x 255 mm 13, 2" x 10" 255 mm / 10" 218 x 305 mm 8, 58" x 12" 255 x 360 mm 10, 04" x 14, 17" Anslut + kabeln till den röda terminalen och - kabeln till den svarta. Use the template coming with the speaker to cut or saw a hole for the speaker frame. Remove the grille from the plastic frame by pushing two of the wings from the backside. The screws that became visible when you removed the grille, has wings attached that will swing out behind the wall or roof panel when you turn the screws clockwise. Don´t tighten the screws too hard, there is a risk that you deform the plastic frame. When installed in a soft panel in the ceiling, use a piece of MDF or particle board to reinforce the installation. [. . . ] If the speaker is returned for service, please include the original dated receipt with the product. For technical assistance, ask the shop where the product was sold, or the distributor in your very country. You can always send an e-mail to info@dls. [. . . ]