User manual DMC DELFINO 125

[. . . ] OWNER S MANUAL IMPORTANT NOTICE WELCOME Thank you for purchasing an Daelim vehicle. OPERATOR AND PASSENGER This motorcycle is designed to carry the operator and one passenger. WARNING Attempting to change the pre-set maximum speed may cause danger and will void the Daelim warranty. ON-ROAD USE This motorcycle is designed to be used only on the road. READ THIS OWNER'S MANUAL CAREFULLY Pay special attention to statements preceded by the following words: WARNING Indicates a strong possibility of severe personal injury or death if instructions are not followed. CAUTION Indicates a possibility of personal injury or equipment damage if instructions are not followed. NOTE Gives helpful information. This manual is an important and integral part of your vehicle. [. . . ] (2) Press the socket spring, turn counter clockwise. (4) Replace the bulb with new one install in the reverse order of removal. BULB REPLACEMENT METHOD Be sure to turn a main switch "OFF" prior to replacement of a bulb. After replacement with new bulb, check for proper operation. HEADLIGHT BULB CAUTION Care is to be taken to avoid leaving fingerprints on a headlight bulb. Failing to observe this may cause early damage of the headlight bulb resulted from concentration of heat. Be sure to wear clean gloves when replacing a bulb. If touched to it with bare hands, clean it with a cloth soaked with alcohol to prevent from early damage. SOCKET HEADLIGHT ASS' Y <INSPECTION OF WINKER> Turn a main switch "ON". Check the lamp for proper operation (front/rear and right/left) and sound by operating the switch, and also a lens for damage or contamination. 28 <HEADLIGHT LUMINATION ANGLE> Adjust headlight lumination angle by turning an adjusting bolt on a headlight. (Use type screwdriver. ) (1) Adjust the verticality by turning the screw on leftside. (2) Adjust the horizontality by turning the screw on rightside. <TAIL/STOP LIGHT BULB> (1) Loosen 2 tapping screws to disassemble tail light lens. (2) Press a bulb with a light force and rotate it to counterclockwise to disassemble it. Apply reverse order of disassembly for assembly. TAIL/STOP LIGHT BULB : 12V 21/5W TAIL/STOP LIGHT LENS CAUTION When disassembling, care is to be taken for ensuring that a tail light lens can not be damaged. When replacing a tail light lens, be sure to assemble lens seal securely. CAUTION Lumination angle adjusted incorrectly may dazzle a facing driver's eyes or result in difficulty to show the forward. STOP LIGHT BULB 29 <WINKER BULB> Front Winker Bulb (1) Loosen tapping screw to disassemble a winker lens. (2) Press a bulb with a light force and rotate it to counterclockwise to disassemble it. Apply reverse order of disassembly for assembly. FRONT WINKER BULB: 12V 10W FR. COVER Rear Winker Bulb (1) Loosen two tapping screws to disassemble a tail light lens and a winker lens. (2) Press a bulb with a light force and rotate it to counterclockwise to disassemble it. Apply reverse order of disassembly for assembly. REAR WINKER BULB: 12V 10W RR. WINKER BULB REAR VIEW MIRROR Check the objects at the back are well noticed when seating on a driver's seat, and also mirror for damage or contamination. FUEL LEAK INSPECTION Check there is no gasoline leakage from fuel tank, hoses, carburetor, etc. WINKER BULB 30 MAINTENANCE The Required Maintenance Schedule specifies how often you should have your motorcycle served, and what things need attention. It is essential that your motorcycle be served as scheduled to retain its high level of safety, dependability, and emission control performance. These instructions are based on the assumption that the motorcycle will be used exclusively for its designed purpose. Sustained high speed operation, or operation in unusually wet or dusty conditions, will require more frequent service than specified in the MAINTENANCE SCHEDULE. Consult your authorized Daelim dealer for recommendations applicable to your individual needs and use. 31 MAINTENANCE SCHEDULE Perform the Self Inspections Before Operation at each scheduled maintenance period. [. . . ] Restart the vehicle after 2~3 min when it is turned over. Always turn on the headlight at night. 48 STARTING Prior to starting always look around to avoid accident. Get on the vehicle after pulling back the stand. Start driving slowly after turning on the winker and releasing the brake while ensuring the safety around the vehicle. CAUTION Return the side stand to its original position. [. . . ]