User manual DOD D12

[. . . ] The exclamation point indicates that it is necessary for the user to refer to the owner's manual. These symbols warn that there are no user serviceable parts inside the unit. Do not attempt to service the unit yourself. Refer all servicing to qualified personnel. [. . . ] This will allow any signal connected to the mixer to be sampled by the D12. Connect monitor to seperate input for headphone monitoring. Connect microphone (with XLR-1/4" cable) directly to D12. input. Dimension12 RECORD Select bank 1, 2, 3, or 4 (6 seconds each) or 1&2 or 3&4 (12 seconds each) Press record button (record LED will light indicating record is active). Press stop when done or wait until the full record time has finished. (Monitor out plays dry signal only. ) GATED RECORD Select bank. Record LED flashes waiting for input signal. PLAY Select desired bank, and press Play Button (3). If no edit point is set, play will start at the beginning of the sample. If an edit point is set then play will begin at specified start point. (Monitor out will play selected bank only. ) LOOPING Press the desired bank, press the Loop Button (14), (LED will light indicating loop is active), press Play Button (3). The sample will play from beginning to the end of the 6 or 12 second sampling time, depending on which was selected. With looping on, the sound sample will then continue to be repeated. If the start and stop points were changed using the editing funtion, play will start from the new start point and end with the new end point (see editing). Looping will continue to play between the new start and stop points until the Stop Button (4) is pressed. REVERSE The Gate/Reverse Button (5) will cause the sample to be played backwards. To stop the reverse playback, press the Stop Button (4), and then press Gate/Reverse Button. OVERLAYS Two banks my be played back together, either bank 1 and 2 or 3 and 4. For example, this function my be accomplished by pressing bank 1 and the Play Button (3), and then pressing bank 2 and the Play Button (3). Each bank can have its own set of above functions independently associated with each bank, i. e. , bank 1 for instance may be played in reverse with effects, and its own separate stutter, while bank 2 can be played forward with no effects and its own stutter point. 3 4 Dimension12 STUTTER The Stutter Button (6) is used on the "fly", that is while the sound sample is being played, the Stutter Button (6) is pressed at the point where you want the sample to "stutter". When the Stutter Button (6) is pressed the first time, the Stutter LED lights indicating a stutter point has been selected. Subsequent presses of the Stutter Button (6) will return the sound sample to the stutter point and begin playing from that point. If the sound sample has played to the end and stopped (play LED off) and a stutter point has been set, pressing the Stutter Button (6) now will initiate play mode and will start the sound sample playing from the stutter point. [. . . ] The warranty registration card must be mailed within ten days after purchase date to validate the warranty of this DOD product. DOD warrants this product (1 year parts, 1 year labor ), when used solely within the U. S. , to be free from defects in material and workmanship under normal use and service. DOD Electronics liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned through the original dealer, or an authorized DOD sevice center where all parts and labor will be covered up to a period of one (1) year. The company shall not be responsible for any consequential damage as a result of the products use in any circuit or assembly. [. . . ]