User manual DOD FX35

[. . . ] Do not attempt to service the unit yourself. Refer all servicing to qualified personnel. Opening the chassis for any reason will void the manufacturer's warranty. If liquid is spilled on the unit, shut it off immediately and take it to a dealer for service. [. . . ] Creating a Preset Suppose you want to create a preset that has medium compression, Grunge distortion, boosted highs and lows on the EQ, a low threshold setting on the noise gate, a chorus, no delay, and a room reverb. Let's also suppose that you wanted the expression pedal to control the reverb level. The steps outlined below will guide you through creating this preset. Page 9 1. Press the effect select button under the Compression group. The display will show the current status of the compressor. If the compressor is bypassed (indicated by two dashes "--"), press the Compression button again, or rotate the Data Wheel to activate the compressor. Since we want a medium compression setting, roll the Data Wheel until the number 2 shows in the display. You have now set the compressor to a medium threshold setting. The next step is to select the Grunge distortion. Press the effect select button in the Distortion group. The display will show the current status of the distortion effect. We also wanted to have the Chorus as an effect in our example preset. If the effects in this group are bypassed (indicated by two dashes "-" in the display), press the Effect button again, or rotate the Data Wheel to activate this group. Chorus is listed as the first effect in this group so, roll the Data Wheel until the number "1" is shown in the display. You will notice that when you select Chorus as your effect type, the parameter LEDs next to Speed, Depth, and Mix/Level will light. This indicates that these three parameters are associated with the Chorus, and are available for adjustment. Press the Parameter Edit button once and the LED next to Speed will begin to flash. The display will show the current value of the Chorus speed. Use the Data Wheel to increase or decrease the speed of the Chorus. For our example, let's set the speed to 5. Press the Parameter Edit button again and the LED next to Depth will begin to flash. The display will show the current value of the Depth parameter. [. . . ] Rock the expression pedal forward to the toe down position and press the flashing footswitch 1. Rock the pedal back to the toe up position and now press the flashing footswitch 3. The expression pedal is now calibrated for use with all programs. Calibrating the Expression Pedal If the expression pedal ever has problems with controlling parameters between their full range, it may be necessary to re-calibrate it. [. . . ]