User manual DOD FX52

[. . . ] Only user programs can be selected with the bank footswitch. To select the Factory Presets you must use the Up/Down buttons. To make life easy, factory presets are duplicated in all the user locations. Editing programs 30 user slots have been provided for you to fill with programs of your own. [. . . ] In order to change, add, or delete an effect simply push the Effect Selector button (4), this selects the effect to edit, the currently selected effect number will appear in the LED Display (5). Then use the Up/down buttons (9) to increment up or down through the effects and effect values. When the desired effect has been found, press the Store Button (6). When the Store Button (6) has been pressed, the store light will blink, this is the VoTEC asking where you would like the program saved. Use the Up/down buttons (9) to select desired program number, press the Store Button (6) one more time to save. To remove a currently active effect, press the Effect Selector button (4) twice and -- will appear, then press the Store Button (6). If the effect is currently bypassed press the selector button to activate. Bypassing To bypass, simply press the Footswitch (1) of the program you are currently using . bp will appear in the LED Display (5), this will bypass the VoTEC completely. To re-engage the VoTEC, press any footswitch. Factory reset Caution this function will revert VoTEC to factory default. Hold down both the Compressor and Reverb buttons while powering up the VoTEC. Also controls wah ranges, and autowah/envelope sensitivity. Effect selector buttons These buttons allow you to select the effects you wish to use or bypass. Display The LED display in program mode shows which bank and program is currently selected. In Edit mode it shows the number and/or status of the selected effect. Store Button Use this button to store your custom programs in the user memory location of choice. Up/Down buttons These buttons scroll up/down selected effects (edit mode), or up/down through banks/presets (performance mode). Input Knob Controls the overall input level from your mic. Clip LED The clip LED lights when clipping occurs at the input of the VoTEC, To eliminate clipping, reduce the setting of your input level by adjusting the Input knob. Allow the LED to light occasionally with peak signals. 1/4" HiZ Output jack Connect cable from this jack to your mixers input, also doubles as headphone output. 1/4" HiZ Input jack Plug in your microphone here. VoTEC OWNERÕS MANUAL 1 DIGITAL/ANALOG PRESETS FACT O RY P RES ET S T Y ST BANK 1 01- Vocal Chorus with Delay and Reverb 02- Vocal Delay "Slappin' Elvis" 03- Vocal Flange BANK 2 11- Echo with Flange 12- Fifth Down with Pitch Shift 13- Vox Distortion with Detune BANK 3 21- Tremolo with Distortion 22- DARTH VADER 23- Detuned Echo with Reverb BANK 4 31- Slapback Distortion 32- Compressor with Chorus 33- Cavern BANK 5 41- Detuned Delay 42- "The ole' Distorted Microphone" 43- Breathy Flange BANK 6 51- Tremolo with short Reverb 52- Phaser with short Delay 53- Chorus with short Delay BANK 7 61- Multi-Tap Delay and Detune 62- Verb 63- Fast Chorus BANK 8 71- "The whole Shebang distorted" 72- "The whole Shebang clean" 73- Harmonica Flange BANK 9 81- Enveloped Phaser 82- Enveloped Flanger 83- Mucho Enveloped Flanger BANK 10 91- Devil Boy 92- Robot Ring Modulator 93- Pixellator FX LIS T S Master Level: 0-99 Mix Level: 0-99 Noise Gate/F. B. S. : G1-9: S1-2: S3-4: F1-3: Increase gate threshold and hysteresis Fast swell with increasing thresh. [. . . ] 1/4" HiZ Input jack Plug in your microphone here. VoTEC OWNERÕS MANUAL 1 DIGITAL/ANALOG PRESETS FACT O RY P RES ET S T Y ST BANK 1 01- Vocal Chorus with Delay and Reverb 02- Vocal Delay "Slappin' Elvis" 03- Vocal Flange BANK 2 11- Echo with Flange 12- Fifth Down with Pitch Shift 13- Vox Distortion with Detune BANK 3 21- Tremolo with Distortion 22- DARTH VADER 23- Detuned Echo with Reverb BANK 4 31- Slapback Distortion 32- Compressor with Chorus 33- Cavern BANK 5 41- Detuned Delay 42- "The ole' Distorted Microphone" 43- Breathy Flange BANK 6 51- Tremolo with short Reverb 52- Phaser with short Delay 53- Chorus with short Delay BANK 7 61- Multi-Tap Delay and Detune 62- Verb 63- Fast Chorus BANK 8 71- "The whole Shebang distorted" 72- "The whole Shebang clean" 73- Harmonica Flange BANK 9 81- Enveloped Phaser 82- Enveloped Flanger 83- Mucho Enveloped Flanger BANK 10 91- Devil Boy 92- Robot Ring Modulator 93- Pixellator FX LIS T S Master Level: 0-99 Mix Level: 0-99 Noise Gate/F. B. S. : G1-9: S1-2: S3-4: F1-3: Increase gate threshold and hysteresis Fast swell with increasing thresh. Increasing Feedback suppression Modulations: C0-C9: F0-F9: P0-P9: t0-t8: r0-r6: I0-I9: S0-S9: d0-d8: H0-H2: A0-A2: B0-B9: E0-E9: Chorus, 3 slow, 3 medium, 4 fast. Tremolo, Increasing speed, variable depths. Pixellator, 1-6 increasing pixellation, 7-9 random. [. . . ]