User manual DOD FX7

[. . . ] OWNER'S MANUAL GUITAR EFFECTS PROCESSOR/PREAMP A Harman International Company SAFETY INSTRUCTIONS (EUROPEAN) CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN NOTICE FOR CUSTOMERS IF YOUR UNIT IS EQUIPPED WITH A POWER CORD. WARNING: THIS APPLIANCE MUST BE EARTHED. The cores in the mains lead are coloured in accordance with the following code: GREEN and YELLOW - Earth BLUE - Neutral BROWN - Live A T T E N T I O N : RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR W A R N I N G : TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE The symbols shown at left are internationally accepted symbols that warn of potential hazards with electrical products. The lightning flash with arrowpoint in an equilateral triangle means that there are dangerous voltages present within the unit. [. . . ] The Jam-A-LongTM signal is mixed with your instrument signal at both the main and headphone outputs so you can play along with your favorite tunes. 3) HEADPHONE OUTPUT - This stereo mini phone plug is for your headphones. The overall headphone level is controlled by the Output level knob. 4) LEFT / MONO OUT - For stereo applications, this is the Left main output. 5) RIGHT OUT - For stereo applications, this is the Right main output. For mono applications, leave this jack unconnected. 6) VOLUME/WAH CONTROLLER INPUT - This 1/4" connector is used to connect most volume pedals or 0/+5v controller pedal to the FX7 for real-time control of wah and volume functions. 7) AC POWER INPUT - Connect the supplied AC power adapter to this jack. Use only the adapter supplied with the FX7. Use of any other adapter may damage the unit. 8) POWER CORD STRAIN RELIEF - This clip prevents the AC power cord from being accidentally pulled out. 6 FX7 owner's manual signal processing Hooking Up DO NOT APPLY POWER TO THE FX7 UNTIL INSTRUCTED. 1) STEREO: Connect the Left and Right outputs to a pair of guitar amplifiers, or the inputs of a mixing console. If you're using guitar amps, set the tone controls flat (no boost or cut) and balance the levels between them. If you're using a console, pan the FX7 input channels hard left and right, and turn down the high frequency EQ for best results. MONO: Connect the Left output to a guitar amplifier or input of a mixing console. 2) 3) Connect your instrument to the input of the FX7. OPTIONAL: Connect a volume type or 0/+5v controller pedal to the Controller input of the FX7. Make sure the pedal is connected before you apply power to the FX7. Power up the FX7 by connecting the supplied AC adapter between the FX7 and a power outlet. Play your instrument and watch the Clip LED on the FX7 carefully as you set the Input knob. Turn up the input level until the Clip LED begins to light, and reduce the input level slightly. When the Input knob is set properly, the Clip LED should not flicker on the loudest passages. [. . . ] To bypass individual effects: 1) From Program mode, decide which effect you want to bypass and press its Select button twice. The display reads: -. 10 FX7 owner's manual signal processing Press the effect Select button to toggle the effect in and out of bypass mode. REMEMBER: The decimal point indicates that the value shown in the display is not the stored value. To bypass the selected Program: 1) Press the currently selected Program footswitch on the pedalboard. [. . . ]