User manual DOD FX86

[. . . ] One advantage of the FX86B is it will oscillate when the R. I. P. (LEVEL) control is turned up, allowing oscillation at any amp volume. [. . . ] Alternate guitar or bass tunings aid in the quest to raise the dead with music. Try tuning to C# (C#, F#, B, E, G#, C#) or C (C, F, Bb, Eb, G, C). This will give your guitar or bass that mean tone. When setting up the effect, use the R. I. P. (LEVEL) control to match the level of the distortion effect with the level of the original input signal. The control should be set so that there is a slight increase in level when the effect is switched into the signal path. The GUTS (LOW) knob controls the low-frequency (bass) content of the signal (when the effect is on). Turning this control clockwise increases the lowfrequency content of the signal. The SCREAM (HIGH) knob control the high-frequency (treble) content of the guitar signal (when the effect is on). This control adds more edge to your sound, allowing your guitar sound to shatter glass (or at least sound like it). The PAIN (MID) knob controls the mid-frequencies and can make your skin crawl if turned up. When it's turned down, it makes the GUTS (LOW) and SCREAM (HIGH) controls even more effective. On the following pages, some examples of different types of sounds are shown, along with graphic representations of how to set the knobs. Since good (or bad) guitar sounds are a subjective matter, use these examples as starting points to create your own sounds that meet your specific tastes, or lack thereof. CONNECTING THE FX86B Connect your guitar to the input of the FX86B. Connect the OUTPUT of the FX86B to your amp (or to the input of another effects device you may be running). [. . . ] The warranty registration card must be mailed within ten days after purchase date to validate this warranty. DOD Warranty Product Options: All (requires a Class II power adapter that conforms to the requirements of EN 60065, EN 60742, or equivalent). The product herewith complies with the requirements of the Low Voltage Directive 73/23/EEC and the EMC Directive 89/336/EEC as amended by directive 93/68/EEC. Manufacturer's Name: DOD Electronics Corporation Copyright © 1998 DOD Electronics Corporation Printed 2/98 FX86B 18-0038-B Manufacturer's Address: 8760 S. Sandy Parkway Sandy, Utah 84070, USA European Contact: Your Local DOD Sales and Service Office or Safety: EN 60065 (1993) IEC65 (1985) with Amendments 1, 2, 3 International Sales Office 3 Overlook Drive #4 Amherst, New Hampshire 03031, USA Tel (603) 672-4244 Fax (603) 672-4246 DECLARATION OF CONFORMITY International Distribution 3 Overlook Drive Unit 4 Amherst, New Hampshire 03031 U. S. A. [. . . ]