User manual DOD PHASER201

[. . . ] Another unique feature to the SR 460 is its slow audio rampup feature. The audio has an approximate 750 millisecond ramp-up time on power-up to prevent damage to hearing caused by loud audio pops. It also gives you time to turn down the volume if previous settings are too loud. [. . . ] It also gives you time to turn down the volume if previous settings are too loud. All inputs and outputs are 1/4 inch TRS The SR 460 is another innovative product brought to you by DOD Electronics. F RONT PANEL FUNCTIONS The front panel and controls of the SR 460 headphone amplifier are as follows: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 1. STEREO FRONT INPUT/OUTPUT - A high impedance, high sensitivity plug-in connection that acts as an output or a Loop-through input. POWER SWITCH This LED indicates internal signal clip from input device. This control controls the overall amount of signal fed to each channel. This knob controls the output of signal in channel 1. This jack is used for the headphone output in channel 1. This knob controls the output of signal in channel 2. Opening the chassis will void the warranty. All service and repair must be performed by the factory for the warranty to remain in service. Headphone Amp Man. 6/8/99 10:57 AM Page 4 Should a problem arise with the Amplifier, please contact your authorized DOD Electronics dealer for return/repair procedures. S PECIFICATIONS Inputs: Input impedance: Outputs: Minimum headphone impedance: Maximum Power output: THD : Power Requirements: Frequency response: 1/4" TRS stereo unbalanced (front and rear) 1/4" TRS mono balanced - Left channel (rear only) 1/4" TRS mono balanced - Right channel (rear only) 40K balanced - 20K unbalanced 6 TRS 1/4" stereo 32ohm - All Outputs - Single output is capable of 8 ohm load. 1 watt stereo per channel 0. 75% @ 0. 250 w 120V AC 50-60Hz 20 watt max. The warranty registration card must be mailed within ten days after purchase date to validate the warranty of this DOD product. DOD warrants this product, when used solely within the U. S. , to be free from defects in material and workmanship under normal use and service. DOD Electronics liability under this warranty is limited to repairing or replacing defective materials that show evidence of defect, provided the product is returned through the original dealer, where all parts and labor will be covered up to a period of three years. The company shall not be responsible for any consequential damage as a result of the products use in any circuit or assembly. Proof of date of purchase is considered to be the burden of the consumer. [. . . ] The company shall not be responsible for any consequential damage as a result of the products use in any circuit or assembly. Proof of date of purchase is considered to be the burden of the consumer. DOD reserves the right to make changes in design or make improvements upon this product without incurring any obligation to install the same on PRODUCTS PREVIOUSLY MANUFACTURED. [. . . ]