User manual DOLMAR AT-3623

[. . . ] Cutter blade Guard Nylon cutting head Guard extension Two bolts Protector cover Hex wrench Receive washer Clamp washer Cup Hex nut Threaded spindle Lever 27. Model Type of handle No load speed Overall length Cutting blade diameter Cutting diameter with nylon cutting head Net weight Rated voltage High Low AT-3623 Bike handle 0 - 7, 300 min-1 0 - 5, 300 min-1 1, 880 mm 230 mm 7. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Specifications and battery cartridge may differ from country to country. [. . . ] MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. Be careful not to drop or strike battery. Always stop tool operation and charge the battery cartridge when you notice less tool power. Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. Always be sure that the equipment is switched off and the battery cartridge is removed before adjusting or checking function on the equipment. Before inserting the battery cartridge into the equipment, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. 7 & 8) To prevent the switch trigger from being accidentally pulled, a lock-off button is provided. to start the equipment , depress the lock-off button and pull the switch trigger. The tool speed is increased by increasing pressure on the switch trigger. Always switch off the equipment before insertion or removal of the battery cartridge. To remove the battery cartridge, withdraw it from the equipment while sliding the button on the front of the cartridge. To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. Ask your local authorized service center for repairs. [. . . ] Keep the side with letters on the spool visible on the top. Now, unhook the ends of the cord from their temporary position and feed the cords through the eyelets to come out of the housing. Then push cover firmly onto the housing to secure it. Make sure the latches fully spread in the cover. [. . . ]