User manual DOLMAR ES-31 A PARTS LIST 2003-11

[. . . ] Please read, understand and follow this booklet, which refers in detail to the various points that will demonstrate its outstanding performance. This will assist you to safety obtain the best possible results from your DOLMAR Blower. It is very important to understand the following symbols when reading this instructions manual. Hot surfaces - Burns to fingers or hands To ensure correct and safe operation, the user must read, understand and follow this instruction manual to assure familiarity with the handling of the blower (1). [. . . ] 1) When the engine is cold, or when the fuel it refueled (1) Set this machine on a flat space. (4) Continue to push the primer pump until fuel enters into the primer pump. (6) Hold the element cover with a left hand to prevent the engine from moving, settle down to take the stable position. (7) Pull out slowly the starter handle till a certain resistance is felt. Return the starter handle backward once from this position, then pull it out with force. Once the start knob is pulled, never release your hand immediately. Hold the start knob until it returns to its original point. (8) When the engine starts , open the choke lever. Open the choke lever progressively while checking the engine operation. be sure to open the choke lever to the full in the end. In cold or when the engine is cooled down, never open the choke lever suddenly. If the oil filled above the limit, it may be contaminated or may catch fire with white smoke. Initially, every 20 operating hours, and subsequently every 50 operating hours SAE10W-30 oil of API Classification SF Class or higher (4-stroke engine oil for automobile) Oil Change Procedure Please follow these steps when changing the oil: (1) Set the blower down on a level surface. (2) Place a waste oil container under the drainage hole (1) to catch the oil as it drains out. The container should have a capacity of at least 220 ml to be able to catch all of the oil. (3) Loosen the oil drain bolt (2) to let the oil drain out. Be careful not to allow oil to get on the fuel tank or other parts. Caution: Be careful not to lose the gasket (aluminum washer) (3). Place the oil drain bolt (2) in a location where it will not accumulate dirt. (Removing the oil cap (4) allows the oil to drain easily. ) Caution: Be sure to set the oil cap (4) down in a location where it will not accumulate dirt. (5) As the level of the oil being drained decreases, tilt the blower over on to the side with the drain so that the oil will completely drain out. [. . . ] Dolmar must warrant to the ultimate purchaser and each subsequent owner that the engine or equipment is: (1) Designed, built, and equipped so as to conform with all applicable regulations adopted by the Air Resources Board; and (2) Free from defects in materials and workmanship that causes the failure of a warranted part for a period of two years. (c) The warranty on emissions-related parts will be interpreted as follows: (1) Any warranted part that is not scheduled for replacement as required maintenance in the written instructions required by subsection (d) must be warranted for the warranty period defined in Subsection (b)(2). If any such part fails during the period of warranty coverage, it must be repaired or replaced by the manufacturer according to Any such part repaired or replaced under the warranty must be warranted for the remaining warranty period. (2) Any warranted part that is scheduled only for regular inspection in the written instructions required by subsection (d) must be warranted for the warranty period defined in Subsection (b)(2). [. . . ]