User manual DOLMAR ES-36 A PARTS LIST 2003-11

[. . . ] 9-10 Please read, understand and follow this booklet which refers in detail Operation . This will assist you to safety obtain the best possible Operation method . It is very important to understand the following symbols when reading this instructions manual. To ensure correct and safe operation, the user must read, understand and follow this instruction manual to assure familiarity with the handling of the blower (1). [. . . ] Exhaust gas from the engine has toxic consequences. Do not operate the engine in a poorly-ventilated place, such as in a tunnel, building, etc. - Operating the engine in the poorly-ventilated place may cause poisoning by exhaust gas. In case of detection of any abnormality in sound, odor, vibration after start, stop the engine immediately and carry out inspection. - If the engine is operated without attending such abnormality, an accident may occur. Confirm that the engine stops when the stop switch is set to "O" position. 1) When the engine is cold, or when the fuel it refueled (1) Set this machine on a flat space. (2) Set the stop switch to " I " position. (3) Continue to push the primer pump until fuel enters into the primer pump. (6) (5) Hold the main handle with a left hand to prevent the engine from moving, settle down to take the stable position. (6) Pull out slowly the starter handle till a certain resistance is felt. Deteriorated engine oil will shorten the life of the sliding and rotating parts to a great extent. Be sure to check the period and quantity of replacement. In general, the engine main unit and engine oil still remain hot just after the engine is stopped. In replacement of oil, confirm that the engine main unit and engine oil are sufficiently cooled down. Otherwise, there may remain a risk of scald. In addition just after of the engine stopping because oil does not finish to return in the oil case, becomes cause of the oil inserting too much. If the oil filled above the limit, it may be contaminated or may catch fire with white smoke. Initially, every 20 operating hours, and subsequently every 50 operating hours SAE10W-30 oil of API Classification SF Class or higher (4-stroke engine oil for automobile) - Keep the oil gauge free from dust or dirt. (4) Please make the machine vertical (under the protector), refill oil to the shelf inside the oil pipe. (5) After refill , securely tighten the oil gauge. Insufficient tightening of the oil gauge will lead to oil leakage. [. . . ] (b) General Emissions Warranty Coverage. Dolmar must warrant to the ultimate purchaser and each subsequent owner that the engine or equipment is: (1) Designed, built, and equipped so as to conform with all applicable regulations adopted by the Air Resources Board; and (2) Free from defects in materials and workmanship that causes the failure of a warranted part for a period of two years. (c) The warranty on emissions-related parts will be interpreted as follows: (1) Any warranted part that is not scheduled for replacement as required maintenance in the written instructions required by subsection (d) must be warranted for the warranty period defined in Subsection (b)(2). If any such part fails during the period of warranty coverage, it must be repaired or replaced by the manufacturer according to Any such part repaired or replaced under the warranty must be warranted for the remaining warranty period. [. . . ]