User manual DOLMAR ES-4 A PARTS LIST 2003-11

[. . . ] This will assist you to obtain the best possible result from your DOLMAR Brush Cutter/String trimmer. You will note the following symbols when reading the instructions manual. Wear eye and ear protection (for String trimmer only) Take Particular care and Attention Wear protective helmet, eye and ear protection (for Brush Cutter only) Top permissible tool speed Keep distance Keep the area of operation clear of all persons and pets ­ To ensure correct operation, user has to read this instruction manual to make himself familiar with the handling of the Brush Cutter/String trimmer. Users insufficiently informed will risk danger to themselves as well as others due to improper handling. [. . . ] Move at least 3m away from the place of refuelling. Place the brush cutter on a clean piece of ground taking care that the cutting tool does not come into contact with the ground or any other objects. Low speed High speed Choke opening: ­ Full closing in cold or when the engine is cold. ­ Full or half opening in restart just after stop of operation. 3) Primer pump Continue to push the primer pump until fuel enters into the primer pump. 4) Recoil starter ­ Pull the start knob gently until it is hard to pull (compression point). Then, return the start knob, and pull it strongly. Once the start knob is pulled, never release your hand immediately. Hold the start knob until it returns to its original point. ­ Open the choke lever progressively while checking the engine operation. be sure to open the choke lever to the full in the end. Release the throttle lever to run the engine idle and then squeeze the throttle lever fully. Repeat this procedure until the nylon cord feeds out to the proper length. If the nylon cord is too short to feed out automatically with the above procedure, bump the knob of the nylon cutting head against the ground to feed out the nylon cord. If the nylon cord does not feed out with procedure 2, rewind/replace the nylon cord by following the procedures described under "Replacing the nylon cord". ­ Press on the housing latches inward to lift off the cover, then remove the spool. ­ Hook the center of new nylon cord into the notch in the center of the spool, with one end of the cord extending about 80mm (3-1/8") more than the other. Then wind both ends firmly around the spool in the direction of the head rotation (left-hand direction indicated by LH and right-hand direction by RH on the side of the spool). ­ Wind all but about 100mm (3-15/16") of the cords, leaving the ends temporarily hooked through a notch on the side of the spool. Keep the side with letters on the spool visible on the top. Now, unhook the ends of the cord from their temporary position and feed the cords through the eyelets to come out of the housing. Then push cover firmly onto the housing to secure it. [. . . ] A list of the Factory Service Center locations and phone numbers are provided below for your convenience. , La Mirada, California, (herein "MAKITA") warrant to the initial retail purchaser and each subsequent owner, that this utility equipment engine (herein "engine" ) was designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U. Environmental Protection Agency (EPA), and that the engine is free of defects in materials and workmanship which would cause this engine to fail to conform with EPA regulations during its warranty period. For the components listed under PARTS COVERED, Makita Factory Service Center or service center authorized by Makita will, at no cost to you, make the necessary diagnosis, repair, or replacement necessary to ensure that the engine complies with applicable U. [. . . ]