User manual DOLMAR GE-1100 PARTS LIST 2006-05

[. . . ] This will assist you to obtain the best possible result from your DOLMAR Petrol Brushcutter. You will note the following symbols when reading the instructions manual. Read instruction manual and follow the warnings and safety precautions! Wear protective helmet, eye and ear protection! [. . . ] ­ Adjust the strap length so that the cutter blade will be kept parallel with the ground. ­ In an emergency, push the notches (1) at both sides, and you can detach the machine from you. Be extremely careful to maintain control of the machine at this time. Do not allow the machine to be deflected toward you or anyone in the work vicinity. WARNING: Failure to maintain complete control of the machine at all could result in serious bodily injury or DEATH. ­ In an emergency, push the notches (2) at both sides, and you can detach the machine from you. Be extremely careful to maintain control of the machine at this time. Do not allow the machine to be deflected toward you or anyone in the work vicinity. WARNING: Failure to maintain complete control of the machine at all could result in serious bodily injury or DEATH. Move at least 3 m away from the place of refuelling. Place the Petrol Brushcutter on a clean piece of ground taking care that the cutting tool does not come into contact with the ground or any other objects. NOTE: To increase the service life of the cutter blade it may be turned over once, until both cutting edges have become blunt. The nylon cutting head is a dual string trimmer head capable of both automatic and bump & feed mechanisms. The nylon cutting head will automatically feed out the proper length of nylon cord by the changes in centrifugal force caused by increasing or decreasing rpms. However, to cut soft grass more efficiently, bump the nylon cutting head against the ground to feed out extra cord as indicated under operation section. Low speed (under 4, 800 min-1) is not suitable, the nylon cord will not feed out properly at low speed. The most effective cutting area is shown by the shaded area. If the nylon cord does not feed out automatically proceed as follows: 1. Release the throttle lever to run the engine idle and then squeeze the throttle lever fully. Repeat this procedure until the nylon cord feeds out to the proper length. If the nylon cord is too short to feed out automatically with the above procedure, bump the knob of the nylon cutting head against the ground to feed out the nylon cord. If the nylon cord does not feed out with procedure 2, rewind/replace the nylon cord by following the procedures described under "Replacing the nylon cord. [. . . ] (c) The warranty on emissions-related parts will be interpreted as follows: (1) Any warranted part that is not scheduled for replacement as required maintenance in the written instructions required by subsection (d) must be warranted for the warranty period defined in Subsection (b) (2). If any such part fails during the period of warranty coverage, it must be repaired or replaced by the manufacturer according to Subsection (4) below. Any such part repaired or replaced under the warranty must be warranted for the remaining warranty period. Any warranted part that is scheduled only for regular inspection in the written instructions required by subsection (d) must be warranted for the warranty period defined in Subsection (b) (2). [. . . ]