User manual DOLMAR GS-120 PARTS LIST 6-98

[. . . ] If the plug does not fit fully into the extension cord, reverse the plug. If the plug still does not fit, obtain a correct polarized extension cord. A polarized extension cord will require the use of a polarized wall outlet. This plug will fit into the polarized wall outlet only one way. [. . . ] For your safety, this tool is equipped with a triple switching system. To turn on the tool, press two out of three triggers A, B and C. Release either one of the two pressed triggers to turn off. The sequence of switching is unimportant as the tool only starts when both switches are activated. CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. To trim the hedge straight, pull triggers A and B. When engaging the extension cord, secure it to the tool's cord with the hook complete. Attach the hook about 100 - 200 mm from the extension cord connector. Cut upwards with both hands pull the switch triggers B and C and move it in front of your body. CAUTION: Do not attach the holder of waist cord hook to other than the extension cord. Do not attach it in a position closer to the tool beyond the hook complete. Overreaching with a hedge trimmer, particularly from a ladder, is extremely dangerous. Do not work from anything wobbly or infirm. CAUTION: Do not force the opening of the holder. Do not attempt to cut branches thicker than 10 mm diameter with this trimmer. These should first be cut with shears down to the hedge trimming level. To cut a hedge top evenly, it helps to tie a string at the desired hedge height and to trim along it, using it as a reference line. Do not cut off dead trees or similar hard objects. Hold the trimmer with both hands pull the switch trigger A or B and move it in front of your body. Attaching the chip receiver (accessory) on the tool when trimming the hedge straight can avoid cut off leaves' being thrown away. When operating the hedge trimmer, keep extension cord behind trimmer. As a basic operation, tilt the blades towards the trimming direction and move it calmly and slowly at the speed rate of 3 - 4 seconds per meter. [. . . ] At this time, the chip receiver needs to be installed so that its hooks fit into grooves in the shear blade unit. Smear the blade before and once per hour during operation using machine oil or similars. After operation, remove dust from both sides of the blade with wired brush, wipe off it with a rag and then apply enough low-viscosity oil, such as machine oil etc. CAUTION: Before removing or installing shear blade, always be sure that the tool is switched off and unplugged. [. . . ]