User manual DOLMAR GS-121 PARTS LIST 6-98

[. . . ] Never use the cord to carry the tools or pull the plug from an outlet. Keep cord away from heat, oil, sharp edges or moving parts. When operating a power tool outside, use an outdoor extension cord marked "W-A" or "W". These cords are rated for outdoor use and reduce the risk of electric shock. [. . . ] Many accidents are caused by poorly maintained tools. Use only accessories that are recommended Accessories that may be suitable for one tool, may become hazardous when used on another tool. Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified personnel could result in a risk of injury. When servicing a tool, use only identical replacement parts. Follow instructions in the Maintenance section of this manual. Use of unauthorized parts or failure to follow Maintenance instructions may create a risk of electric shock or injury. Make sure your extension cord is in good condition. When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An undersized cord will cause a drop in line voltage resulting in loss of power and overheating. Table 1 shows the correct size to use depending on cord length and nameplate ampere rating. Do not touch the workpiece immediately after operation; it may be extremely hot and could burn your skin. ALWAYS wear proper apparel including long sleeve shirts, leather gloves and shop aprons to protect skin from contact with hot cuttings. Use of this tool to cut some products could expose user to dust containing hazardous substances. use appropriate respiratory protection. The tool must be used only for dry cutting. CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Only case you adjust the cutting depth to the maximum one, always be sure to do the adjustment after adjustment of the wheel guard. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. CAUTION: The wheel guard must be adjusted on the tool so that the closed side of the guard always points toward the operator. The wheel guard can be adjusted about 80 degrees, after you loosen the clamping nut. CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. [. . . ] When the resin insulating tip inside the carbon brush is exposed to contact the commutator, it will automatically shut off the motor. When this occurs, both carbon brushes should be replaced. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. [. . . ]