User manual DOLMAR HT-155 PARTS LIST 1-01

[. . . ] The HT-556 D and HT-576 E models are especially handy and robust hedge trimmers, with plenty of performance and a good power-to-weight ratio. The ergonomic design of the grips and controls make for comfortable and untiring operation during extensive jobs. Table of contents Conformity Declaration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Packaging . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Delivery inventory . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Hold each grip with your thumb around it. CAUTION: The blade will still run for a short time after you release the throttle (free-running effect). HT-2576 E Use the trimmer in such a way that exhaust cannot be inhaled. Do not work in enclosed spaces (poisoning hazard). Immediately turn off the engine if there is any noticeable change in the way the tool runs. Always turn off the engine before checking the condition of the tool, taking care of problems or refuelling (10). 9 Before starting the hedge trimmer ensure that you have a safe footing. Always turn off the engine before removing any jammed cuttings from the cutter. If the cutter touches rocks, nails or other hard objects, immediately switch off the engine and check the blade. Do not put the overheated power hedge trimmer in dry grass oronanyinflammableobjects. Themufflerisveryhot(danger offire). 10 When stopping work or leaving the working place switch off the hedge trimmer (10) and put it down such that nobody is endangered. Maintenance Stopping work Refuelling Transport Putting out of function 5 Working technique - - Work only in good lighting and visibility. Be especially careful on slippery and wet surfaces, ice, and snow (danger of slipping). Pay attention to obstacles in the work area - risk of stumbling!Never use the trimmer while standing on a ladder. Always cut away from your body. - After use, clean the trimmer, in particular the cutter. In addition, a long service life and reliable operation with a minimum emission of exhaust gases are ensured. DOLMAR high-performance two-stroke engine oil is available in the following sizes to suit your individual requirements: 1l order number 980 008 107 100 ml order number 980 008 106 In case DOLMAR high-performance two-stroke engine oil is not available, it is urgently recommended to use a mixture ratio of 40:1 with other two-stroke engine oils, as otherwise optimum operation of the engine cannot be guaranteed. Caution: Do not use ready-mixed fuel from petrol stations. The correct mixture ratio: 50:1 It is not wise to add more engine oil than specified to ensure safe operation. This will only result in a higher production of combus-tion residues which will pollute the environment and clog the exhaust channel in the cylinder as well as the muffler. In addition, fuel consumption will rise and performance will decrease. Fuels have a limited storage life. Therefore fuel and fuel mixtures, which have been stored for too long, can cause starting problems. Purchase only that amount of fuel, which will be consumed over the next few months. Store fuel safely in a dry place in approved containers only. The Storage of Fuel 40:1 NOTE: when using DOLMAR high-performance two-stroke engine oil, i. mix 50 parts gasoline with 1 part oil. AVOID SKIN AND EYE CONTACT when using other two-stroke engine oils, i. mix 40 parts gasoline with 1 part oil. Mineral oil products degrease your skin. [. . . ] In case of damage, haverepairedbyaqualifiedservicecentreimmediately If necessary, have sharpened by a service centre Check for damage. If damaged, have replaced at service centre Check for damage and sharpness Check slide play, if necessary adjust Functional check Check for tightness Clean(morefrequentlyifverydirty) Check (cutter must not move) Cleantomaintaingoodcoolingairflow. Check and replace if necessary Checkforclogging, checkbolts Replace Clean Lubricate (every 10-0 hours) Check at an authorized service centre Clean exterior, check for damage. In case of damage, haverepairedbyaqualifiedservicecentreimmediately Lightly oil Empty and clean Run empty 1 10 12 10 13 13 14 14 Before each start Annually Storage 14 Service, spare parts and guarantee Workshop service Themaintenanceandrepairofmodernhedgetrimmersaswellasallsafetydevicesrequirequalifiedtechnicaltrainingandaspecial workshop equipped with special tools and testing devices. [. . . ]