User manual DOLMAR HT-40 PARTS LIST 8-99

[. . . ] Thank you very much for selecting the DOLMAR Hedge Trimmer. We are pleased to be able to offer you the DOLMAR Hedge Trimmer which is the result of a long development program and many ears of knowledge and experience. The Hedge Trimmer models HT-2145 D/HT-2162 E combines the advantages of state-of-the-art technology with ergonomic design, they are light weight, handy, compact and represent professional equipment for a great variety of applications. For your safety and best tool performance, be sure to read, understand and follow all the safety and operating procedures listed in the instruction manual before operation. [. . . ] ­ For lubricating the engine use a two-stroke engine oil (quality grade:TC-3), which is added to the fuel. The engine has been designed for use with DOLMAR two-stroke engine oil and a mixture ratio of 50:1 only to protect the environment. In addition, a long service life and a reliable operation with a minimum emission of exhaust gases is guaranteed. It is absolutely essential to observe a mixture ratio of 50:1 (DOLMAR 2-stroke engine oil), otherwise the reliable function of the Hedge Trimmer cannot be guaranteed. ­ The correct mixture ratio: Mix 50 parts gasoline with 1 part DOLMAR 2-stroke engine oil (See table on the right) NOTE: For preparing the fuel-oil mixture, first mix the entire oil quantity with half of the fuel required. In an approved can which meets of exceeds all local code standards, then add the remaining fuel. Thoroughly shake the mixture before filling it into the Hedge Trimmer's tank. It is not wise to add more engine oil than specified to ensure safe operation. It will only result in a higher production of combustion residues which will pollute the environment and clog the exhaust channel in the cylinder as well as the muffler. Utmost care is required when handling fuel. fuel may contain substances similar to solvents. Operation of the engine is only permitted after all the appropriate accessories are attached. ­ Before starting, make sure that the cutting device has no contact with objects such as branches, stones, etc. ­ Before trimming, inspect area for wires, cords, glass, or other foreign objects which could come in contact with the blade. Be aware of any and all electric lines and electric fences. Move at least 3 meters away from the place of refuelling. Place the Hedge Trimmer on a clean area of ground make sure that the cutting tool does not come into contact with the ground or any other objects. Cold starting (When the engine is cold or it has been stopped for more than 5 minutes or when fuel is added to the engine. Squeeze first the lock lever A and then the throttle lever B. Keeping the throttle lever B depressed, then press the throttle lock C inward. Keeping throttle lock C depressed, release the throttle lever B. This will lock the throttle lever B in position. [. . . ] Category C=50 hours, B=125 hours, and A=300 hours. , La Mirada, California, (herein "MAKITA") warrant to the initial retail purchaser and each subsequent owner, that this utility equipment engine (herein "engine" ) was designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U. Environmental Protection Agency (EPA), and that the engine is free of defects in materials and workmanship which would cause this engine to fail to conform with EPA regulations during its warranty period. For the components listed under PARTS COVERED, Makita Factory Service Center or service center authorized by MAKITA will, at no cost to you, make the necessary diagnosis, repair, or replacement necessary to ensure that the engine complies with applicable U. [. . . ]