User manual DOLMAR HT-5510

[. . . ] Always follow safety precautions in the Owner's and Safety Manual. Grooves Press the hooks on both sides Unlock the hooks Screws Blade cover Under cover Gear housing cover Crank Ellipse of shear blade Model Blade length Strokes per minute (min-1) Overall length Net weight Safety class HT-5510 550 mm 1, 500 970 mm 4. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. â· Note: Specifications may differ from country to country. [. . . ] Young persons over 16 years of age may be exempted from this restriction if they are undergoing training under the supervision of an expert. Use the hedge trimmer only if you are in good physical condition. If you are tired, your attention will be reduced. Be especially careful at the end of a working day. The user is responsible for all damages to third parties. Never use the trimmer when under the influence of alcohol, drugs or medication. Check to make sure that the voltage and frequency of the power supply correspond to the specifications given on the identification plate. We recommend the use of a residual-current-operated circuit breaker (ground-fault circuit interrupter) with a tripping current of 30 mA or less, or an earth leakage current protector. Work gloves of stout leather are part of the basic equipment of the hedge trimmer and must always be worn when working with it. Also wear sturdy shoes with anti-skid soles. Before starting work check to make sure that the trimmer is in good and safe working order. Check cable for damage before starting work and replace if necessary. The hedge trimmer must not be used unless fully assembled. Always work in such a way that the extension power cord is behind you. Remove plug from the mains immediately if cable is damaged or cut. Make sure you have a secure footing before starting operation. Immediately switch off the motor and unplug the mains plug if the cutter should come into contact with a fence or other hard object. Before checking the cutter, taking care of faults, or removing material caught in the cutter, always switch off the trimmer and unplug the mains plug. Switch off the trimmer and disconnect and secure the mains plug before doing any maintenance work. When moving the hedge trimmer to another location, including during work, always unplug the mains plug. Never carry or transport the trimmer with the cutter running. Clean the hedge trimmer and especially the cutter after use, and before putting the trimmer into storage for extended periods. [. . . ] Do not work from anything wobbly or infirm. Do not attempt to cut branches thicker than 10 mm diameter with this trimmer. These should first be cut with shears down to the hedge trimming level. These accessories or attachments are recommended for use with your DOLMAR tool specified in this manual. [. . . ]