User manual DOLMAR MS-22 C

[. . . ] Important: Read this instruction manual carefully before putting the String Trimmer into operation and strictly observe the safety regulations. Thank you very much for purchasing the DOLMAR String Trimmer. We are pleased to recommend to you the DOLMAR String Trimmer which is the result of a long development programme and many years of knowledge and experience. Please read this booklet which refers in detail to the various points that will demonstrate its outstanding performance. [. . . ] CAUTION: Start the string trimmer only after having assembled it completely. ­ Do not adjust position of the loop handle too close to the control grip ­The standard position of the handle is 200mm to 250mm from the hanger. To meet the applicable safety provisions, only the tool/protector combinations as indicated in the table must be used. Be sure to use genuine DOLMAR nylon cutting head. ­ If the nylon cutting head hits against a stone during operation, stop the engine and check the nylon cutting head immediately. CAUTION: The appropriate protector must always be installed, for your own safety and in order to comply with accident-prevention regulations. Operation of the equipment without the guard being in place is not permitted. ­When using the string head, fit the protector (6) into the protector (1), and tighten them with two nuts (5) and two screws (4). Turn the machine upside down, and you can replace the nylon cutting head. ­ Insert the hex wrench through the hole in the gear case and rotate the receiver washer (3) until it is locked with the hex wrench. NOTE:The clamp washer (2), and nut (1) are not necessary for mounting the nylon cutting head. ­ Make sure that the blade is the left way up. Utmost care is required when handling fuel. fuel may contain substances similar to solvents. Refuel either in a well ventilated room or outdoors. Do not inhale fuel vapors, avoid any contact of fuel or oil with your skin. Mineral oil products degrease your skin. If your skin comes in contact with these substances repeatedly and for an extended period of time, it will desiccate. in addition , allergic reactions may occur. Eyes can be irritated by contact with oil. If oil comes into your eyes, immediately wash them with clear water. If your eyes are still irritated, see a doctor immediately. [. . . ] PARTS COVERED Listed below are the parts covered by the Emission Component Defect Warranty. Some of the parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement point for that part. Bring your sales receipts indicating date of purchase for this engine. The dealer or service center authorized by MAKITA will perform the necessary repairs or adjustments within a reasonable amount of time and furnish you with a copy of the repair order. [. . . ]