User manual DOLMAR PH-6504 PARTS LIST 2006-05

[. . . ] For the components listed under PARTS COVERED, the service dealer authorized by DOLMAR will, at no cost to you, make the necessary diagnosis, repair, or replacement necessary to ensure that the engine complies with applicable U. EMISSION COMPONENT DEFECT WARRANTY PERIOD The warranty period for this engine begins on the date of sale to the initial purchaser and continues for a period of 2 years. PARTS COVERED Listed below are the parts covered by the Emission Components Defect Warranty. Some of the parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement point for that part. [. . . ] Never permit another person to hold the log. Never hold the log with your leg or foot. Never operate a chain saw that is damaged, improperly adjusted or not completely or securely assembled. Follow the maintenance and repair instructions in the appropriate section of this manual. Always stop the engine and make sure that the chain is stopped before commencing any maintenance or repair work or cleaning the saw. Allow the chain saw to cool off before doing any maintenance work (burn hazard)!Chain saws with catalytic converter take longer to cool down!Do not attempt any maintenance or repair work not described in this manual. Have such work performed by your DOLMAR service shop only. Logs under strain require special attention to prevent the saw from pinching. The first cut is made on the compression side to relieve the stress on the log (see fig. Turn the chain tensioning screw (H/13) until the chain tensioning bolt (12) is aligned with the hole in the guide bar. Slightly lift the end of the guide bar and turn the chain adjusting screw (13) to the right (clockwise) until the chain rests against the bottom side of the guide bar. While still holding up the tip of the guide bar, tighten the retaining nuts (2) with the universal wrench. The tension of the chain is correct if the chain rests against the bottom side of the guide bar and can still be easily turned by hand. While doing so the chain brake must be released. Check the chain tension frequently - new chains tend to get longer during use!When checking the chain tension the engine must be switched off. In order to guarantee uniform wear of the guide bar the bar should be turned over whenever replacing the chain. Loosen the nuts (2) about one turn with the universal wrench. Raise the tip of the guide bar a little and turn the chain tensioning screw (13) to the right (clockwise) until the saw chain is again up against the bottom edge of the guide bar (see circle). While keeping the tip of the guide bar raised, tighten the nuts (2) again with the universal wrench. [. . . ] The DOLMAR service centers have all the necessary equipment and skilled and experienced personnel, who can work out costeffective solutions and advise you in all matters. please contact your nearest service center. Should you however not have an adress for a DOLMAR service center then please contact the DOLMAR general trading company (see last page) who will gladly provide you with the adress of your nearest DOLMAR service center. We therefore recommend that you consult a DOLMAR service center for all work not described in this instruction manual. [. . . ]