User manual DOLMAR PM-5100 S3

[. . . ] The operator is responsible for following the warning and safety instructions in this manual and on the lawnmower. Never use the mower unless the grassbox or guards provided by the manufacturer are in the correct position. Explanation of Symbols Flymo Hover Compact Switch off!Remove plug from mains before adjusting, cleaning or if cable is entangled or damaged. [. . . ] 2. Ensure the mains voltage suits your product 3. IMPORTANT!The wires in the mains lead are coloured in accordance with E the following code: L RED BLUE NEUTRAL OR F BROWN BROWN LIVE U S BLACK E The wire which is coloured OR N BLUE BLUE must be connected to the Terminal which is marked with the letter 'N' or coloured BLACK. The wire which is coloured BROWN must be connected to the Terminal which is marked with the letter 'L' or coloured RED. 4. It is important that the outer sheath is clamped correctly into the 3-pin plug. 5. If in doubt consult your local Service Repairer or qualified electrician before the machine is used. 6. A 13 Amp fuse must be fitted to the Mains Plug. 7. The normal plug fuse and household fuse only protect the electrical equipment and are not a safeguard against electrocution. If your product is hard wired i. e. non-detachable mains electric cable, a conversion kit and extension cable is available from all Electrolux Outdoor Products Approved Service Centres which can be found in your local Yellow Pages. Handles A B Preparing your lawnmower for use · Your lawnmower is supplied with the upper handle folded over the machine for packing and transportation. (See Figure A) Handle in Operating Position · Lift handle as illustrated in figure B. · Make sure that the cable does not become trapped between the handles Starting and Stopping C D To Start your Lawnmower 1. Connect female extension cable connector to the back of the switchbox. For a Lower Cut - Add spacers to a maximum of 3. Refit the blade as described in Fitting the Blade and Fan. J Removing and fitting the Blade and Fan Removing the Blade and Fan 1. To remove the blade bolt, hold the fan firmly and with the spanner provided loosen the blade bolt by turning it anti-clockwise (J). Remove the blade bolt, blade, spacers and fan. (L) 3. Inspect for damage and clean as necessary. · Renew your metal blade after 50 hours mowing or 2 years whichever is the sooner - regardless of condition. If the blade is cracked or damaged replace it with a new one. Never use a blade bolt if the insulated head is damaged cracked or missing. Ensure the fan is located correctly. (K) 2. Place the spacers onto the fan ensuring the pegs have located into the holes. (K) 3. Place the blade onto the spacers ensuring the pegs have located into the holes on the blade and ensuring the blades is positioned as illustrated in Figure K. [. . . ] · If necessary, contact your local authority for disposal information. EC Declaration of Conformity I, the undersigned M. Bowden of Electrolux Outdoor Products, Aycliffe Industrial Park, NEWTON AYCLIFFE, Co. Certify that the Lawnmower:Category. . . . . . . . Electrolux Outdoor Products Conforms to the specifications of Directive 2000/14/EEC I, the undersigned M. [. . . ]