User manual DOLMAR PS-420 SC SPARE PARTS LIST

[. . . ] Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Always cover the battery terminals with the battery cover when the battery cartridge is not used. [. . . ] Install saw chain properly according to this instruction manual. Keep all parts of the body away from the saw chain when the motor is operating. Before you start the saw, make sure the saw chain is not contacting anything. Switch off the chain saw immediately if you notice anything abnormal in operation. Carefully inspect the chain saw if you drop or strike it against something hard. When not in use, chain saws should be stored in a dry, and high or locked-up place -- out of reach of children. When storing saw, use a scabbard (chain cover). Also use safety footwear; snug fitting clothing; protective gloves; and head protection. Before making a cut, remove dirt, stones, loose bark, nails, staples and wire from the tree. Secure the workpiece so that it will not move suddenly during operation. To prevent the saw chain from being pinched in the cut, support the workpiece near the cut using blocks or the like. Install the guide bar so that its concave portion will contact the saw chain tension adjusting spring. The saw chain may become loose after many hours of use. From time to time check the saw chain tension before use. Grasp the saw chain in the middle of the guide bar and lift up. The gap between the guide bar and the tie strap of the saw chain should be approx. Then tighten the bolt securely after making sure that gap is approx. Always be sure that the tool is switched off and the battery cartridge is removed before lubricating the saw chain. â· Always use vegetable oil when pruning fruit trees. Lubricate the whole saw chain evenly before each use. Also lubricate it whenever replacing a fully discharged battery cartridge with a charged one. Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. [. . . ] â· Please have your saw chain sharpened at a Makita Authorized Service Center or replace with a new one if your saw chain does not cut correctly. Chips and sawdust will build up in the guide bar groove, clogging it and impairing oil flow. Always clean out the chips and sawdust when sharpening or replacing the saw chain. Remove any chips and sawdust from the tool after removing the chain cover. [. . . ]