User manual DOLMAR PS-9010

[. . . ] Read and understand this Owner's and Safety Manual. Always follow safety precautions in the Owner's and Safety Manual. The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. EMISSIONS COMPONENT DEFECT WARRANTY COVERAGE DOLMAR warrant to the initial retail purchaser and each subsequent owner, that this utility equipment was designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the U. [. . . ] A pinch may result or the limb may fall, causing loss of control. If a pinch occurs, stop the engine and remove the saw, by lifting the limb. The limbs could spring back toward the operator and cause loss of control of the saw or injury to the operator. When cutting small logs, use a sawhorse (fig. Never permit another person to hold the log. Never hold the log with your leg or foot. Never operate a chain saw that is damaged, improperly adjusted or not completely or securely assembled. Follow the maintenance and repair instructions in the appropriate section of this manual. Always stop the engine and make sure that the chain is stopped before commencing any maintenance or repair work or cleaning the saw. Do not attempt any maintenance or repair work not described in this manual. Have such work performed by your DOLMAR service shop only. Keep the chain, bar and sprocket clean and lubricated; replace worn sprockets or chains. Logs under strain require special attention to prevent the saw from pinching. The first cut is made on the compression side to relieve the stress on the log (see fig. If the saw pinches, stop the engine and remove it from the log. You can spot a dull chain when easy-to-cut wood becomes hard to cut and burn marks appear on the wood. Tighten all nuts, bolts and screws except the carburetor adjustment screws after each use. Keep spark plug and wire connection tight and clean. Store saws in a high or locked place, away from children. Only properly trained professionals should work in an area where the logs, limbs and roots are tangled (i. Drag the logs into a clear area before cutting. 1 Handle 2 Choke 3 Cover for air filter / spark plug 4 Switch for use in winter 5 Tubular handle 6 Muffler with spark arrester screen 7 Fastening nuts 8 Spike bar (toothed stop for holding saw steady against wood) 13 Hand guard 14 Guide bar 15 Chain 16 Hand guard (release for chain brake) 17 Starter grip 18 Adjusting screws , , H-T-L" for carburetor 19 ON/OFF switch 20 Stop knob for halfway throttle 21 Safety locking button 22 Throttle lever 23 Fuel tank cap 24 Fan housing with starting assembly 25 Oil tank cap 9 Chain catcher 10 Adjusting screw for oil pump (bottom side) 11 Sprocket guard 12 Identification plate Power at speed Max. [. . . ] In case of any doubts, please, contact your salesman who is responsible for the guarantee of a product. We ask for your understanding that we cannot accept any responsibility for damage caused by: · Use of guide bars and chains which have not been approved. Use of guide bar and chain lengths which have not been approved. Use of force, improper use, misuse or accidents. [. . . ]