User manual DOLMAR RM-72.13 H

[. . . ] Cette condition peut facilement être obtenue par l'application d'un poids d'un gramme à l'extrémité la plus légère de la lame: si celle-ci tend à s'abaisser au-delà de la ligne d'équilibre, cela veut dire que l'équilibrage est correct tandis que si elle reste soulevée, il s'avèrera indispensable d'alléger l'autre extrémité. Dear Customer, We thank you for having purchased our riding mower and hope that it will fully meet all your expectations. This manual has been compiled in order that you may get to know your machine and to be able to use it safely and efficiently. Don't forget that the manual forms an integral part of the machine so keep it handy so that it can be consulted at any time, and pass it on to the purchaser if you resell the machine. [. . . ] If the malfunction continues, refer to chapter «7» of this manual and to the engine booklet. IMPORTANT Always bear in mind that the safety devices prevent the engine from starting if safety requirements have not been met (see page 26). The pilot lamp will begin flashing if the key is held in the «START» position when the safety devices have been activated. The machine has not been approved for use on public roads. It has to be used (as indicated by the highway code) in private areas closed to traffic. NOTE When moving the machine, the blade must be disengaged and the cutting deck put at its highest position (position «7»). Put the accelerator control between the «SLOW» and «FAST» positions, and the gear change lever in the 1st speed position. Keep the pedal pressed down and disengage the parking brake. Slowly release the pedal which will turn from «brake» to «clutch», thus operating the rear wheels. The pedal has to be released gradually as a sudden engagement may cause tipping up and loss of control of the vehicle. Gradually reach the desired operating speed using the accelerator and gear lever. To change the gear speed the clutch must be used pushing the pedal down half way. Put the accelerator control between the «SLOW» and «FAST» positions. press the brake pedal to disengage the parking brake and release the pedal. Move the speed change lever in the «F» direction and go to the required speed by using the lever and the accelerator. The lever must be moved gradually as a sudden engagement of drive to the wheels may cause tipping and loss of control of the machine. To brake, first reduce the speed on the accelerator to avoid overloading the brake assembly and then push the pedal down fully. To brake, press the brake pedal which will simultaneously make the speed change lever return to the «N» position. The machine MUST be stopped before reverse can be engaged. Push down the pedal until the machine stops and then insert reverse by moving the lever sideways and putting it into position «R». Gradually release the pedal to engage the clutch and then begin moving in reverse. The machine MUST be stopped before reverse can be engaged. [. . . ] STONE-GUARD KIT For use in place of the grass-catcher when the cuttings are not to be collected. "CB01" MAINTENANCE BATTERY-CHARGER This makes it possible to keep the battery in good working order when the machine is in storage, guaranteeing an optimum level of charge and a longer life to the battery. KIT FOR "MULCHING" It finely chops the grass cuttings and leaves them on the lawn, instead of collecting them in the grass-catcher 0 km/h Inside turning circle (minimum diameter of uncut area . Guarantee DOLMAR guarantees the highest quality and will therefore reimburse all costs for repair by replacement of damaged parts resulting from material or production faults occurring within the guarantee period after purchase. [. . . ]