User manual DOMENA CR 3 ECOFIBRES DATASHEET

[. . . ] Congratulations on purchasing this Domena Ironing centre CR3 ecofibres® ecofibres® are mainly made from natural fibres such as fine shavings from trees like spruce. This allows a reduction in unit weight, and ensures a total recycling of the material. Natural fibres are a renewable resource, which allows the material to keep its original technical properties whilst remaining ecological. Ecofibres are totally recyclable, and reduce the use of petrochemicals in manufacturing. [. . . ] 2 or more mauve squares : we advise you to use distilled water for irons. Remove the water tank from its housing by pulling it towards you. Never fill the reservoir with hot water. Refilling whilst ironing You can fill the reservoir during ironing. It is not necessary to switch off or unplug your ironing centre when refilling. ⷠRemove the anti-scale cartridge from the water tank and fill it. To obtain steam, the anti-scale cartridge must be inserted into the water tank. We recommend that you iron articles in the order indicated on the iron's thermostat dial so that the temperature gradually increases. To use steam please ensure that the thermostat dial is set within the 2 and 3 dot settings. Adjust the steam output to suit the type of material being ironed. The volume of steam increases gradually as you turn the control knob towards the maximum. ⷠAt maximum setting, there is an initial burst of steam lasting for several seconds. the steam output will then return to the normal rate. To repeat this process, wait for a few seconds to avoid any risk of spotting. Never call for steam when there is no water in the reservoir. please note · Because of the high steam output rate, there is no need to continually press the steam button. Pressing the button briefly and frequently will enable you to control the quantity of steam, in order to obtain professional results. It also prolongs the life of your anti-scale cartridge. ⷠIf the iron is used intensively, steam may continue to be produced after the steam button has been released and water may appear on the iron holder. There is no risk of the metal being damaged. ⷠYou should turn the steam output dial to the middle setting when - the unit is used for the first time, - the water tank has been refilled, - the anti-scale cartridge has just been changed. It is recommended that you use the ECO function when the garments are only slightly creased, have come out of a tumble dryer and whenever you think suitable. [. . . ] B) If the water-softening cartridge is not changed, the EMC system itself stops the production of steam after a certain amount of ironing time. An audible warning then sounds if you press the steam trigger. To produce steam again, either the antiscale cartridge must be changed or distilled water must be used. After changing the cartridge, the unit must be turned off and on again in order to recreate normal operating conditions (Wait 30 seconds before the trying to use the iron. [. . . ]