User manual DOMENA EASYBOX NEO

[. . . ] Congratulations on purchasing this Domena steam ironing station EasyBox neo. Important advice When using the machine, the following basic precautions should be taken : – Carefully read the instructions before using the appliance for the first time. bei nicht fachgerechter Reparatur entfällt der – Garantieanspruch. € This machine should only be used for its intended purpose: ironing and pressing. [. . . ] The volume of steam increases gradually as you turn the control knob towards the maximum (+). At maximum setting, there is an initial burst of steam lasting for several seconds. The steam output will then return to the normal rate. To repeat this process, wait for a few seconds to avoid any risk of spotting. € If the iron is used intensively, steam may continue to be produced after the steam button has been released and water may appear on the iron holder. There is no risk of the metal being damaged. € You should turn the steam output dial to the middle setting: - when the unit is used for the first time - each time the water tanks has been refilled - each time the anti-scale cartridge has been changed. press the steam button to obtain steam. Never call for steam when there is no water in the reservoir. Because of the high steam output rate, there is no need to continuously press the steam button. Pressing the button briefly and frequently will enable you to control the quantity of steam, in order to obtain professional results and save time. It also prolongs the life of your anti-scale cartridge. To use the Eco mode, press the button marked “Mode Eco”. The illuminated pilot light will confirm that this mode is operational. Each time the appliance is plugged in, press the “Mode Eco” button to use this function. When in “Mode Eco”, the variable steam control is not active (volume of steam cannot be adjusted). It is recommended that you use the ECO function when the garments are only slightly creased, have come out of a tumble dryer and when ever you think suitable. In this way you will be obtaining maximum economy in the use of water and electricity, up to 50% in electricity and 70% in water. Pull out the electric cable as far as you need. Plug the power cable into an earthed socket. The power on light flashes to indicate that the appliance is connected to the mains. The appliance is ready when the power on light is permanently on and when an audible signal sounds to indicate that the appliance is ready to supply steam. [. . . ] - Press the steam button until steam does arrive. - Wait until the on/off pilot light is on - Fill the reservoir. - Insert the reservoir and push it fully in. - Put the dial to the settings ●● – ●●●. [. . . ]