User manual DOMENA XL PRO 90 ECOFIBRES DATASHEET

[. . . ] ­ Do not use your iron whilst the power cord is still in the cord storage clip (hot surface). ­ Do not use the iron if it is damaged, if it leaks, or if the power cable is damaged. To avoid any risk of electric shocks, do not dismantle your iron. Take it to your nearest After Sales Service dealer for servicing or repair ­ Great care must be taken when ironing in the presence of children. [. . . ] At that point you will hear an audible signal. If you press the steam trigger before the appliance is ready, an audible signal sounds to indicate that the generator is not ready to supply steam. ⷠOnce the appliance is ready, press the steam trigger until steam comes out. When you switch on the iron, it may take up to 90 seconds before you can call for steam. The steam output will remain at a reduced level until the generator light goes out, by which time it will have reached the normal level. Please note : Whilst you are ironing, the generator and iron heating pilot lights repeatedly go on and off. This is normal, and you can continue to iron and to use the steam. Adjust the flow control knob to suit the type of material being ironed. The volume of steam increases gradually as you turn the control knob towards the maximum (+). ⷠAt maximum setting, there is an initial burst of steam lasting for several seconds. the steam output will then return to the normal rate. To repeat this process, wait for a few seconds to avoid any risk of spotting. Never call for steam when there is no water in the reservoir. please note · Because of the high steam output rate, there is no need to continually press the steam button. Pressing the button briefly and frequently will enable you to control the quantity of steam, in order to obtain professional results. It also prolongs the life of your anti-scale cartridge. ⷠIf the iron is used intensively, steam may continue to be produced after the steam button has been released and water may appear on the iron holder. There is no risk of the metal being damaged. ⷠSelect maximum steam output when : - the unit is used for the first time, - the water tank has been refilled, - the anti-scale cartridge has just been changed. To ensure regular steam output performance, your unit is equipped with a pump which is activated each time the steam trigger is pressed. : - the appliance is used for the first time - the water tank is empty - the anti-scale cartridge has just been changed. During normal use the pump has a gentle humming sound. [. . . ] - Power supply problem - Appliance not plugged in or On/Off button not pressed - Other - Thermostat dial at the off position - Other - When you call for steam right at the start, - if it seems slow in coming through just keep your finger on the steam trigger until it does arrive. - Appliance not ready - Wait 90 seconds. - The reservoir is empty - Fill the reservoir - The reservoir is incorrectly inserted or has not been inserted. - Insert the reservoir and push it fully in - The anti-scale cartridge has not been inserted - Insert an anti-scale cartridge into the reservoir - The pilot light flashes - Change the anti-scale cartridge. [. . . ]