User manual DOMENA XM-4 90

[. . . ] Remove the water reservoir from its housing by pulling it towards you. Remove the anti-scale cartridge from the bag. It must rest on the bottom of the reservoir. Fill the reservoir to the maximum level. [. . . ] THERMOSTAT ADJUSTMENT • Adjust the thermostat of the iron according to the fabric. € To use steam please ensure that the thermostat dial is set within the 2 and 3 dot settings. TO OPERATE - HEATING PROCESS • Plug the power cable into an earthed socket. € According to model : Turn the variable steam control knob to the High position. € Wait 90 seconds for the appliance to be ready. At that point you will hear an audible signal. If you press the steam trigger before the appliance is ready, an audible signal sounds to indicate that the generator is not ready to supply steam. € Once the appliance is ready, press the steam trigger until steam comes out. When you switch on the iron, it may take up to 90 seconds before you can call for steam. Please note : Whilst you are ironing, the generator and iron heating pilot lights repeatedly go on and off. This is normal, and you can continue to iron and to use the steam. - 16 - STEAM FLOW RATE CONTROL KNOB Adjust the flow control knob to suit the type of material being ironed. Gradually steam setting • The volume of steam increases gradually as you turn the control knob towards the maximum. € At maximum setting, there is an initial burst of steam lasting for several seconds. The steam output will then return to the normal rate. To repeat this process, wait for a few seconds to avoid any risk of spotting. Never call for steam when there is no water in the reservoir. Please note • Because of the high steam output rate, there is no need to continually press the steam button. Pressing the button briefly and frequently will enable you to control the quantity of steam, in order to obtain professional results. It also prolongs the life of your anti-scale cartridge. € If the iron is used intensively, steam may continue to be produced after the steam button has been released and water may appear on the iron holder. There is no risk of the metal being damaged. [. . . ] The machine does - Appliance not plugged in or On/Off button not pressed - Other not heat up. The iron does not heat - Thermostat dial at the off position up. - The reservoir is empty - The reservoir is incorrectly inserted or has not been inserted. - The anti-scale cartridge has not been inserted - The pilot light flashes - Other Water is produced with - The iron soleplate is not hot enough the steam. [. . . ]