User manual DOMENA XM5 PRO ECOFIBRES DATASHEET

[. . . ] The pump can be heard humming during normal use. When using the machine, the following basic precautions should be taken : ­ Before connecting your iron to the mains, make sure that your mains voltage corresponds to the voltage indicated on the rating plate. ­ This machine should only be used for its intended purpose: ironing and pressing. ­ When unplugging the machine, pull the plug, not the cable. [. . . ] Do not use : Rain water, water from the fridge, water from any evaporator appliance, water produced by a condenser tumble drier, water supplied by your water softener if it indicates that the regenerating salts need replacing (incompatibility with the EMC system) Choosing your water You can use either tap water or distilled water for irons. Depending upon the limescale level of your tap water and upon your weekly ironing load (average time : 2/3 hours), it can be more economical to use distilled water for irons (not for car batteries). In this case, your cartridge should last up to 1 year (depending on the amount of your ironing and on the quantity of steam you ask for). Remove, shake it for a few seconds and wait for the resultant colour change (approximately 1 minute). 1 or 1 1/2 mauve squares : you can use tap water. 2 or more mauve squares : we advise you to use distilled water for irons. Never fill the reservoir with hot water Never add products containing alcohol or essences (perfume, eau de Cologne, lavender essence. You can refill the reservoir during ironing. You do not need to unplug the appliance, and can immediately re-commence ironing. To use steam please ensure that the thermostat dial is set within the 2 and 3 dot settings. Plug the power cable into an earthed socket. According to model : Turn the variable steam control knob to the High position. ⷠWait 90 seconds for the appliance to be ready. At that point you will hear an audible signal. If you press the steam trigger before the appliance is ready, an audible signal sounds to indicate that the generator is not ready to supply steam. ⷠOnce the appliance is ready, press the steam trigger until steam comes out. When you switch on the iron, it may take up to 90 seconds before you can call for steam. Please note : Whilst you are ironing, the generator and iron heating pilot lights repeatedly go on and off. This is normal, and you can continue to iron and to use the steam. Adjust the flow control knob to suit the type of material being ironed. Gradually steam setting The volume of steam increases gradually as you turn the control knob towards the maximum. At maximum setting, there is an initial burst of steam lasting for several seconds. [. . . ] - Press the steam button several times - Go to your local dealer - Press the steam button several times. - Fill the reservoir - Insert the reservoir and push it fully in - Go to your local approved service dealer - Insert an anti-scale cartridge into the reservoir - No danger It will stop when steam trigger has been pressed a few times. The iron does not heat - Thermostat dial at the off position up. - The reservoir is empty - The reservoir is incorrectly inserted or has not been inserted. [. . . ]