User manual DOMETIC RM1350

[. . . ] ® Rm1350 FORYOURSAFETY Ifyousmellgas: 1. Openwindows. 4. Immediatelycallyourgassupplier. USER manUal REfRigERatoR foR lP-gaS & ElEctRic oPERation POURvOTRESéCURITé Sivoussentezuneodeurdegaz: 1. Ouvrezlesfenêtres. 4. Avertissezimmédiatementvotre fournisseurdegaz. FORYOURSAFETY Donotstoreorusegasolineorother flammable vapors and liquids in the vicinityofthisoranyotherappliance. POURvOTRESéCURITé Nepasentreposerniutiliserdel'essence ni d'autres vapeurs ou liquides inflammables à proximité de cet appareil ou de tout autreappareil. !WARNING Improperinstallation, adjustment, alteration, serviceormaintenancecancause injuryorpropertydamage. Refertothis manual. Forassistanceoradditionalinformation consult a qualified installer, serviceagencyorthegassupplier. Une installation, un réglage, une modification, uneréparationouunentretiennon conformeauxnormespeutentraînerdes blessures ou des dommages matériels. [. . . ] when all the frost has melted, dry the interior with a clean cloth. Replace the food and set the thermostat to the coldest setting for a few hours. Then, reset the thermostat to the desired setting, usually at mid setting. maintEnancE & SERVicE CAUTION If your refrigerator stops cooling, immediately turn the refrigerator off and see a Dometic dealer. StoRagE PRocEdURE / WintERizing thE REfRigERatoR Rm1350im, Rm1350mim & Rm1350Wim The refrigerator is equipped with a heater tape wrapped around the water solenoid valve and outlet water tube. During cold weather operation below 32°F/0°C the automatic temperature switch will turn the heater tape on automatically. If the RV is in storage and the refrigerator or the DC power is turned OFF there will be no 12V DC present to operate the heat tape; therefore, it will be necessary to drain and dry the ice maker and the water dispenser (if applicable). This will prevent water from freezing in the solenoid valve or becoming stale and producing bad tasting ice. If the temperatures are expected to reach or exceed 0°F/-18°C the ice maker and water dispenser (if applicable) must be drained to prevent component damage and leaks. For instructions, see the following sections DRaINING ThE ICE MakER and DRaINING ThE waTER DIsPENsER. - 1 - maintEnancE & SERVicE dRaining thE icE makER Draining of the ice maker must be performed by qualified service personnel only. water, compressed air and aC power are required. Before starting the draining procedure, make sure the RV is level!TO DRaIN ThE ICE MakER, FOLLOw ThEsE sTEPs: 1. Place a shallow pan under water solenoid valve. Remove inlet fitting to ice maker water solenoid valve. WATER SOLENOID VALVE - RM1350IM 4. Remove the plastic nut and water line from outlet side of the water solenoid valve. Connect compressed air onto the inlet fitting of the water solenoid valve. apply aC power to the solenoid valve by forcing the ice maker mold assembly through several harvest cycles. Remove the plastic cover from the mold assembly. The bail arm must be in the down ("ON") position. start the harvest cycle with a flat blade screw driver inserted into the center of the small gear. Water inlet hose Inlet fitting for water supply line Plastic nut Metal tube 1/4" water line to ice maker WATER SOLENOID VALVE - RM1350WIM Water inlet hose 11. Turn the gear counter clockwise, when the hold switch closes, the mold assembly will continue to operate through the harvest cycle. During the water fill sequence of the harvest cycle the compressed air will blow out the water trapped in the solenoid valve. Repeat the harvest cycle operation several times. [. . . ] The seller does not authorize any person or company to create any warranty obligations or liability on their behalf. This warranty is not extended by the length of time which you are deprived of the use of the product. Repairs and replacement parts provided under the terms of this warranty shall carry only the non-expired portion of this warranty. In no event shall either seller be liable for incidental or consequential damages. [. . . ]