User manual DOMETIC RM2352 INSTALLATION

[. . . ] RM2352 RM2353 ® INSTALLATION AND OPERATING INSTRUCTIONS REFRIGERATOR FOR LP-GAS AND ELECTRIC OPERATION RM 2352 RM 2353 FOR YOUR SAFETY If you smell gas: 1. FOR YOUR SAFETY Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. For assistance or additional information consult a qualified installer, service agency or the gas supplier. Contents: Installation Operating Instructions Maintenance & Service Page 4 9 11 AVIS Cet appareil doit être réparé seulement par un réparateur autorisé. [. . . ] You may have to repeat the lighting procedure several times to purge the air out of the gas lines. !WARNING Most LP gas appliances used in recreational vehicles are vented to the outside of the vehicle. When parked close to a gasoline pump, it is possible that the gasoline fumes could enter this type of appliance and ignite from the burner flame, CAUSING A FIRE OR AN EXPLOSION. FOR YOUR SAFETY, when refueling, shut off all LP gas appliances which are vented to the outside. 9 GAS OPERATION Before starting the refrigerator, check that all the manual gas valves are in the ON position. Do not forget the manual shutoff valve on the rear of the refrigerator see FIG. Check to be sure that the power cord is properly connected to the power supply. If the refrigerator is equipped for 12 volt DC operation, the tow vehicle or caravan engine should be running to prevent discharging the battery. Turn the knob A to the position marked AC for 120 volt AC operation or DC for 12-volt DC operation. Turn the thermostat knob B to position 4. To shut off the refrigerator turn the knob A to OFF position. THERMOSTAT The refrigerator is equipped with a thermostat that can be adjusted by turning the knob B to different setting to maintain the desired cabinet temperature. At OFF In gas operation, the thermostat closes its main valve and the burner runs continuously at the bypass rate, just enough to keep the burner lit. In electrical operation, the contacts in the thermostat are open and the heating elements are off. At MAX In gas operation, the thermostat allows the burner to remain on high flame continuously. In electric operation, the heating element is ON continuously. Lowest cabinet and freezer temperatures are obtained at this setting. The thermostat can be adjusted between MAX and OFF to obtain the desired cabinet temperature. The closer the knob is to MAX - the colder the cabinet temperature. The closer the knob is to OFF - the warmer the cabinet temperature. When the thermostat reaches the set temperature, it will cut the burner back to bypass or, in electric operation, shut off the heating element. The setting of the thermostat is not critical, but we recommend it be adjusted to maintain a dry frost on the cooling fins. Adjust the thermostat knob closer to MAX when the outside temperature becomes warm. This compartment is not designed for deep or quickfreezing of food. [. . . ] NOTE: The color of the flame shall be clear blue over the slots of the burner. Be sure to reconnect the wire to high voltage electrode. Check the electrode for proper location and gap. 13 Electrode 1/8 to 3/16 (3-5 mm) Burner tube 12. [. . . ]