User manual DOMETIC RM3962

[. . . ] ® USER manUal REfRigERatoR foR lP-gaS & ElEctRic oPERation Rm3762 Rm3962 FOR YOUR SAFETY If you smell gas: 1. Immediately call your gas supplier. POUR vOTRE SécURITé Si vous sentez une odeur de gaz: 1. Avertissez immédiatement votre fournisseur de gaz. FOR YOUR SAFETY Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. POUR vOTRE SécURITé Ne pas entreposer ni utiliser de l'essence ni d'autres vapeurs ou liquides inflammables à proximité de cet appareil ou de tout autre appareil. !WARNING Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. [. . . ] Do not smoke or create sparks when working on or near the LP gas system. Remove the cover from the burner housing. Remove the burner mounting screws and then the burner assembly. Remove the wire and flue baffle from the top of the flue tube. using a flue brush, clean the flue from the top. (Blowing compressed air into the flue will not properly clean soot and scale out of the flue tube. ) 5. Blow out the burner with compressed air. Before removing the burner jet: - Clean burner area of soot and scale that fell out of flue tube. - soak the jet in wood alcohol and blow it out with compressed air. - Reinstall and tighten the burner jet. !Never use an open flame to check for gas leaks. Failure to heed this warning could cause an explosion resulting in death or severe personal injury. 1. Check all connections in the LP gas system for gas leaks. apply a non-corrosive bubble solution to all LP gas connections. The appearance of bubbles indicates a leak and should be repaired immediately! !Do not use a wire or pin when cleaning the burner jet as damage can occur to the precision opening. Failure to heed this warning could cause fire resulting in personal injury. chEcking thE contRol SyStEm Check the control system by connecting/disconnecting the 120V aC power, starting/stopping the engine, etc. chEcking thE lP gaS PRESSURE The LP gas pressure should be checked and the main regulator readjusted if the pressure is incorrect. The correct operating pressure is 11 inches of water column. Measure the LP gas pressure at the test port, just ahead of the burner jet. Ensure that the end of the burner fits into the slot on the burner bracket. Verify that the slots are centered under the flue tube and the thermocouple is positioned properly (tip of thermocouple extends over two slots of burner). THERMOCOUPLE gas equipment assembly SOLENOID VALVE . NUT INLET FITTING MANUAL SHUTOFF VALVE . [. . . ] This warranty is not extended by the length of time which you are deprived of the use of the product. Repairs and replacement parts provided under the terms of this warranty shall carry only the non-expired portion of this warranty. In no event shall either seller be liable for incidental or consequential damages. This includes any damage to another product or products resulting from such a defect. [. . . ]